Operational Checks
Show/hide table
 |
Sudden movement of the machine or release of oil under pressure can cause injury to persons on or near the machine. To prevent possible injury, perform the procedure that follows before the test is done. |
 |
- Start the engine.
- Lower the stabilizers and lift the rear wheels 150 mm (6 inch) off the ground.
- Use the bucket hydraulic control to lower the bucket to the ground and use the bucket to raise the front wheels 150 mm (6 inch) off the ground.
- The engine speed needs to be at LOW idle.
- Move the lever for the forward/reverse shuttle and move the lever for the transmission speeds while the engine is running and the brakes are engaged.
- Operate the machine in each direction and in all speeds. Make a note of the noises that are not normal and find the source of the noises. If the operation is not correct, make reference to the Check List During Operation for problems and for probable causes.
- Lower the machine to the ground.
- Run the engine at LOW idle. Engage the parking brake. Stop the engine.
Caterpillar Information System:
450F Backhoe Loader Transmission (Autoshift) Machine Preparation for Troubleshooting
450F Backhoe Loader Transmission (Autoshift) Transmission Hydraulic System
450F Backhoe Loader Transmission (Autoshift) Transmission Control
450F Backhoe Loader Transmission (Autoshift) Transmission
450F Backhoe Loader Transmission (Autoshift) Torque Converter
450F Backhoe Loader Transmission (Autoshift) General Information
Alternator - Bosch K1/N1 Diode Trio - Test
MH3049 Material Handler Machine Systems Cab Riser Cylinder - Remove and Install - Up/Down
CW14 Pneumatic CompactorMachine Systems Final Drive Planetary (Axle Propel) - Assemble
Alternator - Bosch K1/N1 Regulator - Test
424B and 424B HD Backhoe Loaders Power Train Solenoid Valve (Transmission) - Install
424B and 424B HD Backhoe Loaders Power Train Solenoid Valve (Transmission) - Assemble
450F Backhoe Loader Transmission (Autoshift) Visual Inspection
450F Backhoe Loader Transmission (Autoshift) Power Train Troubleshooting
450F Backhoe Loader Transmission (Autoshift) Pressure Taps
450F Backhoe Loader Transmission (Autoshift) Transmission and Torque Converter - Test
CB44B Vibratory Asphalt Compactor Propel System Piston Pump Neutral - Test and Adjust - Mechanical, Solid Drum
MH3049 Material Handler Operator Controls
770G and 772G Off-Highway Trucks TA2 Technical Inspection {0372, 1000, 7000, 753T, 7565} 770G and 772G Off-Highway Trucks TA2 Technical Inspection {0372, 1000, 7000, 753T, 7565}
2012/09/26 New Pressure Switch Is Now Used On Certain Large Wheel Loaders {1435, 5068, 5091, 5092}
2012/10/09 Procedure to Program Injector Trim Files When Injector Trim Files Are Missing in the ECM of Certain Machine Engines {1290, 1920}
2013/08/12 New Injectors Are Used In Certain C7 and C9 Machine Engines {1251, 1290}
2013/08/06 New Injectors Are Used In Certain C7 and C9 Commercial Engines {1251, 1290}
2012/09/27 Improved Steering Rod for the Certain Asphalt Pavers Is Now Used {4303}