Control Panel
Usage:
Remove Control Panel
1. Disconnect wires (2) from the generator terminal strip.
2. Remove four bolts (1) from the shock mounts.
3. Remove control panel.
Install Control Panel
1. Install control panel and four bolts (1).
2. Connect wires (2) to the generator terminal strip.
Caterpillar Information System:
SR4 GENERATOR Testing And Adjusting
SR4 GENERATOR Systems Operation
SRCR GENERATOR Generator Rewind Data
SRCR GENERATOR Alignment Of Single Bearing Generators (Typical)
SRCR GENERATOR Bearing Retainer And Brush Yoke Assembly
SRCR GENERATOR Rotating Field
SRCR GENERATOR Generator Drive Assembly
SRCR GENERATOR Generator Covers
SRCR GENERATOR SRCR Generators
SRCR GENERATOR Brine Tank Load Test
SRCR GENERATOR Circulating Currents
SRCR GENERATOR Generator Ground
SR4 GENERATOR Generator Bearing (Outside Bearing Type RFA)
SR4 GENERATOR Generator Bearing (Inside Bearing Type RFA)
SR4 GENERATOR Generator Removal
SR4 GENERATOR Alignment Of Single-Bearing Generators (Typical)
SR4 GENERATOR Rotor Assembly
SR4 GENERATOR Stator Assembly
SR4 GENERATOR Systems Operation
FLOOR-STANDING SWITCHGEAR Operation
FLOOR-STANDING SWITCHGEAR Automatic Start-Stop
FLOOR-STANDING SWITCHGEAR Alternating Current Components Troubleshooting
FLOOR-STANDING SWITCHGEAR Automatic Start-Stop Troubleshooting
GENERATOR SET CONTROL PANEL Components