SRCR Generators
Usage:
Introduction
This group applies to Caterpillar Statically Regulated Controlled Rectifier Generators.
The photographic views show a typical generator rather than a specific one.
The generators for different Caterpillar Electric Sets have quite obvious exterior and internal variations. Even with the variations in SRCR generators, these basic disassembly and assembly procedures apply to all SRCR generators.
GENERATOR CROSS SECTION
1. Exciter voltage regulator assembly housing. 2. Generator cover. 3. Rotating field assembly. 4. Stator windings. 5. Vented rear cover. 6. Bearing. 7. Bearing retainer and brush yoke assembly. 8. Brush holder. 9. Collector rings. 10. Hub. 11. Fan.
Caterpillar Information System:
SRCR GENERATOR Brine Tank Load Test
SRCR GENERATOR Circulating Currents
SRCR GENERATOR Generator Ground
SRCR GENERATOR Flywheel Balance Weights
SRCR GENERATOR Linear Vibration
SRCR GENERATOR Remote Voltage Control
SRCR GENERATOR Effect Of Temperature On Voltage Regulation
SRCR GENERATOR AC Voltages Available
SRCR GENERATOR SRCR Generator
SRCR GENERATOR Industrial Division Data Sheets
SRCR GENERATOR Type F Testing And Adjusting
SRCR GENERATOR Type F Systems Operation
SRCR GENERATOR Generator Covers
SRCR GENERATOR Generator Drive Assembly
SRCR GENERATOR Rotating Field
SRCR GENERATOR Bearing Retainer And Brush Yoke Assembly
SRCR GENERATOR Alignment Of Single Bearing Generators (Typical)
SRCR GENERATOR Generator Rewind Data
SR4 GENERATOR Systems Operation
SR4 GENERATOR Testing And Adjusting
SR4 GENERATOR Control Panel
SR4 GENERATOR Generator Bearing (Outside Bearing Type RFA)
SR4 GENERATOR Generator Bearing (Inside Bearing Type RFA)
SR4 GENERATOR Generator Removal