Top Shaft
Usage:
Install Top Shaft
NOTE: Before the top shaft is installed in the housing be sure the front retainers are tight and the rear retainers are loose. This will permit the top shaft to be lowered in position correctly.
1. Use a hoist and sling as a support and put the top shaft in the housing.
2. With the hoist and sling connected, install the bearing caps (2) with bolts (3). This will make sure that all of the top shaft bearings (1) are installed correctly.
3. Tighten the rear retainers (4).
4. Connect all tube assemblies (5) to the top shaft.
5. Lower the top cover (6) on the housing. Make an alignment of the holes in the cover with the holes in the housing.
6. Install the gasket and the top cover (6) with bolts (7).
end by:
a) install the oil manifold
Caterpillar Information System:
7231 MARINE TRANSMISSION Top Shaft
7231 MARINE TRANSMISSION Oil Manifold
7231 MARINE TRANSMISSION Oil Cooler
7231 MARINE TRANSMISSION Selector Valve
7231 MARINE TRANSMISSION Magnetic Strainer And Oil Filter
7231 MARINE TRANSMISSION Oil Pump
7231 MARINE TRANSMISSION Testing And Adjusting
7231 MARINE TRANSMISSION Systems Operation
3208 INDUSTRIAL AND MARINE ENGINE ATTACHMENTS Fan Mounting Pulley Assemblies
3208 INDUSTRIAL AND MARINE ENGINE ATTACHMENTS Mounting Group For AT540, MT643, And MT653 Allison Transmission
3208 INDUSTRIAL AND MARINE ENGINE ATTACHMENTS Rear Stub Shaft
3208 INDUSTRIAL AND MARINE ENGINE ATTACHMENTS Expansion Tank
7231 MARINE TRANSMISSION Clutches
7231 MARINE TRANSMISSION Dump Valve
7231 MARINE TRANSMISSION Clutch Drive Spider
7231 MARINE TRANSMISSION Top Shaft
7231 MARINE TRANSMISSION Idler Gear
7231 MARINE TRANSMISSION Reduction Gear And Planetary
7231 MARINE TRANSMISSION Lower Shaft
7231 MARINE TRANSMISSION Oil Pump (1N9239)
7231 MARINE TRANSMISSION Oil Filter (2S6457)
7231 MARINE TRANSMISSION Control Valve (1N7011)
7231 MARINE TRANSMISSION Directional Clutch (2N4562)
D349 INDUSTRIAL & MARINE ENGINES Introduction