Illustration 1 | g02102275 |
Service tool connector on LH Operator Console |
The service tool connector is located on the right side of the LH console.
Illustration 2 | g02108675 |
Rear View of Machine (1) LH Operator Seat (2) RH Operator Seat (3) Center Console Electrical Panel (4) Screed Platform |
Illustration 3 | g02102299 |
Machine ECM inside the Center Console |
The Machine ECM is located inside the Center Console (3).
Illustration 4 | g02102354 |
Implement (Screed) ECM |
Illustration 5 | g01473873 |
The Implement (Screed) ECM is located under the deck plate on the right side of the screed platform. |
The Implement (Screed) ECM is located under the Screed Platform (4).
Illustration 6 | g01354114 |
(5) LH Operator Console Lock Pin |
Illustration 7 | g02102297 |
LH Operator ECM |
The LH Operator ECM is located under the LH Operator platform. In order to access the ECM, pull the Console Lock Pin (5) and swing the Operator station to the outermost position. Standing at the ground level, the ECM is visible from under the Operator station platform. The RH Operator ECM is located in a similar location under the RH Operator platform.
Illustration 8 | g02132988 |
Engine ECM (Top View with the engine compartment door open) |
For the machine that is being serviced, use the following to locate electrical components and connectors:
- Electrical System Schematic
- Parts Manual
- Operation and Maintenance Manual
The following information is a guide to reading the tables on the back of the Electrical System Schematic.
- The "Component Location" table uses white circles to mark the locations in the profile of the machine and in the area views. Alphabetical letters in the "Machine Location" column indicate a general area of the machine. Refer to the corresponding footnote at the end of the table for a description of the location.
- The "Harness Connector Location" table uses white circles to mark the locations in the general view and in the area views. Alphabetical letters in the "Machine Location" column indicate a general area of the machine. Refer to the corresponding footnote at the end of the table for a description of the location.
Connector Contact Numbers
Illustration 9 | g00554751 |
Electronic Control Module (ECM) |
Illustration 10 | g01090860 |
Machine Harness Connectors J1 and J2 that mate to the ECM. |