Engine Starting
Note: The engine will not start unless the direction control lever is in NEUTRAL.
Show/hide table
| NOTICE |
|---|
|
Do not crank the engine for more than 30 seconds. Allow the starter to cool for two minutes before cranking again. Turbocharger damage can result, if the engine speed is not kept low until the engine oil light/gauge verifies the oil pressure is sufficient. |
Caterpillar Information System:
160M Motor Grader Machine Systems Fuel Tank - Remove
160M Motor Grader Power Train Front Axle - Remove
2008/02/04 A New Service Kit is Available for the Fan Drive Group {1359}
Correct Usage of the Oil Rail Plug for the Cylinder Head on C9 Engines{1100} Correct Usage of the Oil Rail Plug for the Cylinder Head on C9 Engines{1100}
Transportation Information {7000} Transportation Information {7000}
CP54 and CS54 Vibratory Soil Compactors Propel System Direction and Speed Control - Cable
CP54 and CS54 Vibratory Soil Compactors Propel System Propel Lines
IT38H Integrated Toolcarrier and 938H Wheel Loader Braking and Hydraulic Fan System Service Brake System Pressure - Test
CP54 and CS54 Vibratory Soil Compactors Machine Systems Machine Wiring
The Proper Procedures for Troubleshooting Mechanical Unit Injectors (MUI){1251, 1264, 1280, 1288, 1290} The Proper Procedures for Troubleshooting Mechanical Unit Injectors (MUI){1251, 1264, 1280, 1288, 1290}
414E, 416E, 420E, 422E, 428E, 430E, 432E, 434E, 442E and 444E Backhoe Loaders Machine Systems Bank Valve (Loader) - Install - Pilot Operated
414E, 416E, 420E, 422E, 428E, 430E, 432E, 434E, 442E and 444E Backhoe Loaders Machine Systems Bank Valve (Loader) - Remove - Pilot Operated
2007/09/24 The Oil Filter Group is Updated {5056, 5068}
CP54 and CS54 Vibratory Soil Compactors Propel System Piston Motor (Axle Propel)
2007/09/24 The Body Exhaust Arrangement is Updated {1061, 1062}
Arctic Conversion for the Engine in a 587R{1355, 1380} Arctic Conversion for the Engine in a 587R{1355, 1380}
938H Wheel Loader and IT38H Integrated Toolcarrier Hydraulic System Kickout and Positioner - Adjust
CP56, CS56, CP64, CS64, CP74 and CS74 Vibratory Soil Compactors Machine Systems Hydraulic Cylinder (Steering)
CP54 and CS54 Vibratory Soil Compactors Machine Systems Gear Pump (Steering)
2008/02/04 Correction to R1700G Electrical System Schematic {7566}
160M Motor Grader Machine Systems Front Frame to Rear Frame (Articulating Hitch) - Connect
160M Motor Grader Machine Systems Front Frame from Rear Frame (Articulating Hitch) - Separate
2007/11/26 The Remanufactured Control Group is Incorrect for the Application {1901, 7620}
PM-201 Cold Planer C18 Engine Supplement Muffler - Remove and Install