Flywheel Housing Runout Face Runout (Axial Eccentricity) Of The Flywheel Housing:
Usage:
8T5096 Dial Indicator Group Installed
(Typical Example)
1. Fasten a dial indicator to the crankshaft flange so the anvil of the indicator will touch the face of the flywheel housing.
2. Put a force on the crankshaft toward the rear before reading the indicator at each point.
3. With dial indicator set at 0.0 mm (.00 in) at location (A), turn the crankshaft and read the indicator at locations (B), (C), and (D).
4. The difference between lower and higher measurements taken at all four points must not be more than 0.30 mm (.012 in), which is the maximum permissible face runout (axial eccentricity) of the flywheel housing.
Caterpillar Information System:
3176 DIESEL TRUCK ENGINE Flywheel Runout
3176 DIESEL TRUCK ENGINE Front Gear Group
3176 DIESEL TRUCK ENGINE Front Housing Group
3176 DIESEL TRUCK ENGINE Pistons And Rings
3176 DIESEL TRUCK ENGINE Connecting Rods
3176 DIESEL TRUCK ENGINE Connecting Rod And Main Bearing Journals
3176 DIESEL TRUCK ENGINE Crankshaft Seals
3176 DIESEL TRUCK ENGINE Crankshaft
3176 DIESEL TRUCK ENGINE Cylinder Liners
3176 DIESEL TRUCK ENGINE Spacer Block
3176 DIESEL TRUCK ENGINE Cylinder Block Group
3176 DIESEL TRUCK ENGINE Coolant Conditioner Base
3176 DIESEL TRUCK ENGINE Flywheel Housing Bore
3176 DIESEL TRUCK ENGINE Coolant Temperature Sensor
3176 DIESEL TRUCK ENGINE Fuel Pressure Sensor
3176 DIESEL TRUCK ENGINE Speed/Timing Sensor
3176 DIESEL TRUCK ENGINE Throttle Position Sensor
3176 DIESEL TRUCK ENGINE Vehicle Speed Buffer
3176 DIESEL TRUCK ENGINE Support Group-Engine (Front)
3176 DIESEL TRUCK ENGINE Flywheel Group
3176 DIESEL TRUCK ENGINE Adapter Group-Engine To Transmission
3176 DIESEL TRUCK ENGINE Damper Group
3176 DIESEL TRUCK ENGINE Belt Tightener Group
3176 DIESEL TRUCK ENGINE Auxilary Drive Adapter Group (Front power take off)