Engine Oil Filter Housing - Assemble
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 在壳体 (11) 内安装旁通阀 (14) 和弹簧 (13)。
注: 旁通阀在孔中应自由移动。
- 将 O 形密封圈安装在盖 (5) 上。 安装盖 (5) 和螺栓 (4)。
- 将 O 形密封圈安装在盖 (10) 上。 安装盖 (10) 和螺栓 (9)。
- 如有必要,将定位销安装在壳体 (11)中。 定位销必须在壳体面以上
6.50 ± 1.00 mm (0.256 ± 0.040 in) 。 - 在壳体 (11) 上安装 O 形密封圈。 将壳体支架 (6) 安装到壳体 (11)上。 安装螺栓 (12),并拧紧至扭矩为
55 ± 7 N·m (41 ± 5 lb ft) 。 - 在接头 (3) 上安装 O 形密封圈。 将滤清器壳体 (2)和接头 (3)安装在壳体 (11)上。 安装螺栓 (8),并拧紧至扭矩为
55 ± 7 N·m (41 ± 5 lb ft) 。 - 将新的发动机机油滤清器芯安装到滤清器壳体 (2)中。
- 如有必要,将定位销安装在护盖 (7)中。 定位销必须在盖面以上
6.50 ± 1.00 mm (0.256 ± 0.040 in) 。 - 将 O 形密封圈安装在盖 (7) 上。 安装盖 (7) 和螺栓 (1)。
Show/hide table
图 1 | g01113975 |
Show/hide table
弹簧压缩零件如果安装不当,会伤害人体。 为避免伤害,遵照出版的装配程序,并穿上保护装备。 |
结束:
- 安装发动机机油滤清器壳体。 参考拆解与组装, "发动机机油滤清器壳体 - 安装"。
Caterpillar Information System:
3508C, 3512C and 3516C Marine Engines Engine Oil Filter Housing - Disassemble
C9 Engines for Caterpillar Built Machines Vibration Damper and Pulley
143H and 163H Motor Graders Power Train Tandem and Cover - Remove and Install
414E, 416E, 420E, 422E, 428E, 430E, 432E, 434E, 442E and 444E Backhoe Loaders Engine Supplement Radiator, Refrig Condenser, and Hyd and TMSN Oil Cooler - Remove
12H, 140H and 160H Motor Graders Power Train Tandem and Cover - Remove and Install
583T Pipelayer Engine Supplement Prelubrication Oil Pump - Install
AP-1055D and BG-2455D Asphalt Pavers Daily Inspection
CB-214E, CB-224E and CB-225E Vibratory Compactors Machine Systems Piston Pump (Propel) - Assemble
CB-214E, CB-224E and CB-225E Vibratory Compactors Machine Systems Piston Pump (Propel) - Disassemble
16M Series 3 and 18M Series 3 Motor Graders Wheel Lean Bearings - Lubricate
414E, 416E, 420E, 422E, 428E, 430E, 432E, 434E, 442E and 444E Backhoe Loaders Engine Supplement Muffler - Remove and Install
C9.3 Engine for Caterpillar Built Machines Valve Mechanism Cover
2004/11/08 New Engine Software Corrects Warnings of Air Filter Inlet Air Restriction {7620}
414E, 416E, 420E, 422E, 428E, 430E, 432E, 434E, 442E and 444E Backhoe Loaders Engine Supplement Radiator, Refrig Condenser, and Hyd and TMSN Oil Cooler - Install
PS-360C Pneumatic Compactor Machine System Additive Spray System Troubleshooting
PS-360C Pneumatic Compactor Machine System Check Valves (Air on the Run) - Check
583T Pipelayer Power Train Main Drive Shaft - Remove and Install
414E, 416E, 420E, 422E, 428E, 430E, 432E, 434E, 442E and 444E Backhoe Loaders Engine Supplement Hydraulic and Transmission Oil Cooler - Remove
C11 and C15 Engines for Caterpillar Built Machines Injector Solenoid Circuit - Test
2004/10/18 Correction to Operation and Maintenance Manual , "Tire Inflation Information" {4203}
267B, 277B and 287B Multi Terrain Loaders Machine Systems Pilot Hydraulic System
PS-360C Pneumatic Compactor Machine System Air on the Run System Troubleshooting
PS-360C Pneumatic Compactor Machine System Pressure Switch (Air on the Run System Pressure) - Test and Adjust
414E, 416E, 420E, 422E, 428E, 430E, 432E, 434E, 442E and 444E Backhoe Loaders Engine Supplement Hydraulic and Transmission Oil Cooler - Install