Piston Pump (Hydraulic and Steering) - Remove
拆卸步骤
Show/hide table
所需工具     | |||
工具     | 零件号     | 零件描述     | 数量     |
A     | 183-4797     | 履带支重轮起重叉车     | 1     |
FT-2930 | 伸出     | 1     | |
ZZ     | 6V-9511     | 螺塞     | 2     |
6V-9832 | 盖组件     | 2     |
开始:
- 拆下风扇驱动泵。 请参考拆解和组装, "风扇驱动泵 - 拆卸"。
注: 清洁度是一项重要的因素。 拆解步骤开始之前,应彻底清洁部件外部。 这有助于防止尘土进入内部结构。
注: 维修数据:拆卸和安装中的工具 (ZZ) 将不在图示中列出。 显示这一工具是为了协助有经验的维修人员。
Show/hide table
注意 |
---|
在检验、保养、测试、调整及维修产品时,务必留心,确保液体盛装在容器中。 在打开任何腔室或拆解任何储有液体的部件之前,要准备好用合适的容器收集液体。 有关适合收集和盛接卡特彼勒产品上液体的工具及用品,参考专门出版物, NENG2500, "卡特彼勒工具和修理车间设备指南"。 按照当地法规和指令处置所有液体。 |
Show/hide table
滚热的油或液压油的压力会对人员造成伤害。 发动机停机之后,液压油的压力仍会保留在液压系统里。 对液压系统进行维修之前,如果不事先释放压力,可能会造成严重伤害。 卸下液压系统的部件或管路时,确保所有的作业机具都已降到地面上,而且液压油温度已冷。 只能在发动机停机,并且加注口盖冷却到可以用徒手触摸时才能卸下加注口盖。 |
注: 为便于安装,在所有管路、软管、导线和管子上做出识别标记。 插接好所有线路、软管和管路。 这将有助于防止液体泄漏和防止污染物进入系统。
- 断开接头组件 (1) 。
Show/hide table
图 1 | g01012617 |
- 断开软管组件 (2) 。
Show/hide table
图 2 | g01012616 |
- 卸下螺栓 (4) 。
Show/hide table
图 3 | g01012624 |
- 拆下托架 (5) ,然后将托架 (5) 放到旁边。
- 将工具 (A) 连接到适当的起吊设备上。 将工具 (A) 放到机具泵 (3) 下。 拆下机具泵 (3) 。 机具泵 (3) 的重量约为 73 kg (160 lb)。
Show/hide table
图 4 | g01012620 |
Caterpillar Information System:
R1600G Load Haul Dump Brake Release - If Equipped
R1600G Load Haul Dump Ride Control Accumulator - Check - If Equipped
Load Haul Dump Braking System Relief Valve (Brake Accumulator)
R1600G Load Haul Dump Hydraulic System Oil Level - Check
769D Off-Highway Truck and 771D Quarry Truck Operation Information
2003/10/20 New Supports for the Fender Are Available {7252}
CP-533E and CS-533E Vibratory Soil Compactors Propel System Electrical Schematic
769D Off-Highway Truck and 771D Quarry Truck Operator Controls
769D Off-Highway Truck/Tractor and 771D Quarry Truck Operator Controls
C4.4 Industrial Engine Increased Engine Oil Temperature - Inspect
2003/07/21 Improved 159-1610 and 159-1612 Electronic Transmission Control Groups Now Available for Wheel Loaders {4800}
120H and 135H Motor Graders Machine Systems Piston Pump (Hydraulic Fan) - Install
120H and 135H Motor Graders Machine Systems Piston Pump (Hydraulic and Steering) - Install
M325D MH Material Handler Window Washer Reservoir - Fill
2003/08/04 The Nameplate Is Now Bolted to the Grill {7251, 7557}
2003/09/15 An Improved Alternator Belt is Used {1357}
2003/10/01 An Improved Alternator Belt is Used {1357}
CP-533E and CS-533E Vibratory Soil Compactors Hydraulic Tank Breather - Replace
AP-655C and BG-2255C Asphalt Pavers Machine Systems Gear Pump (Vibratory) - Disassemble
AP-655C and BG-2255C Asphalt Pavers Machine Systems Gear Pump (Vibratory) - Assemble
143H and 163H Motor Graders Machine Systems Sideshift Cylinder - Remove and Install
Machine Security System (MSS) Integrated Configuration
773E Off-Highway Truck Operation Information
AP-1055D and BG-2455D Asphalt Pavers Machine Systems Piston Pump (Conveyor) - Disassemble