General Information
转向系统的电子技师屏幕
Show/hide table
图 1 | g00936438 |
底盘 ECM 的"配置"屏幕 |
底盘 ECM 的"配置"屏幕显示参数列表。 如果机器上的转向系统是电子控制的,则"转向蓄能器充注系统安装"参数的"值"必须设为"已安装"。
Show/hide table
图 2 | g00907835 |
底盘 ECM 的"超越参数"屏幕 |
电子技师(ET)内的另一屏幕为底盘 ECM 的"超越参数"屏幕。 如果机器上的转向系统是电子控制的,则"转向蓄能器充注电磁阀电流超越"的"值"的设置范围为 0 至 100%。 百分比代表 0 毫安至 1000 毫安之间的电流值。 如果输入 0% 作为此参数的"值",则底盘 ECM 将向转向泵的排量电磁阀发送 0 毫安的电流。 在 0 毫安时,转向泵处于最大排量和最大流量。 如果输入 60% 或更多作为此参数的"值",则底盘 ECM 将向转向泵的排量电磁阀发送 600 毫安或更大的电流。 在 600 毫安时,转向泵处于最小排量和最小流量。
注: 此时可检查转向泵高压切断阀的设置。 将"值"设为 0% 然后以高怠速操作机器。 可在屏幕顶部处观察到发动机转速和转向蓄能器压力。
Show/hide table
图 3 | g00907838 |
底盘 ECM 的"状态"屏幕 第 6 组 |
"转向蓄能器充注电磁阀电流"是底盘 ECM 第 6 组"状态"屏幕上显示的其中一个参数。 如果机器上的转向系统是电子控制的,则此参数显示的"值"将从 0 更改为 65.0%。 百分比代表 0 毫安至 650 毫安之间的电流值。 如果显示 0% 作为此参数的"值",则底盘 ECM 将向转向泵的排量电磁阀发送 0 毫安的电流。 在 0 毫安时,转向泵处于最大排量和最大流量。 如果显示 65% 或更多作为此参数的"值",则底盘 ECM 将向转向泵的排量电磁阀发送 650 毫安或更大的电流。 在 650 毫安时,转向泵处于最小排量和最小流量。
Caterpillar Information System:
24H Motor Grader Automatic Lubrication System Hydraulic System - Test
CB-534D and CB-564D Asphalt Compactors Engine Starting with Jump Start Cables
R1600G Load Haul Dump Sampling Interval and Location of Sampling Valve
IQAN® Monitoring ; Control System Show Module Information
24H Motor Grader Automatic Lubrication System Hydraulic System
Field Installation of the 224-9412 Quick Coupler Conversion Ar {6129} Field Installation of the 224-9412 Quick Coupler Conversion Ar {6129}
797B Off-Highway Truck Steering System Worksheets
IQAN® Monitoring ; Control System Show Application Information
TH210 and TH215 Telehandlers Braking System General Information Table
2002/12/23 Correction to Operator's Station and Electrical System "Ride Control Circuit (If Equipped)" {7332}
2002/12/23 Correction to Systems Operation Testing and Adjusting "Ride Control Circuit (If Equipped)" {5077}
2002/12/23 Correction to Systems Operation Testing and Adjusting "Ride Control System" {5077}
R1600 Load Haul Dump Articulated Hitch Bearings - Lubricate
797F Off-Highway Truck Steering System Visual Inspection
R1600G Load Haul Dump Automatic Lubrication Grease Tank - Fill - If Equipped
R1600G Load Haul Dump Automatic Lubrication Inline Filter - Clean - If Equipped
R1600G Load Haul Dump Automatic Lubrication Filler Filter - Clean - If Equipped
TK711, TK721, TK722 and TK732 Track Feller Bunchers Hydraulic System Relief Valve (Line for Travel Motor) - Test and Adjust
8-16B Extend-A-Mat Screed Thickness Control - Lubricate
R1600 Load Haul Dump Backup Alarm - Test
IQAN® Monitoring ; Control System Change Contrast
R1600G Load Haul Dump Automatic Brake Application System (Low Transmission Oil Pressure) - Test - If Equipped
797 Off-Highway Truck Steering System Machine Preparation for Troubleshooting
8-16B Extend-A-Mat Screed Safety Messages