Diagnostic Code CID 0800 FMI 09 May Log Against VIMS At Power Up Caterpillar


Diagnostic Code CID 0800 FMI 09 May Log Against VIMS At Power Up

Usage:

WHEEL LOADERS

WHEEL TRACTORS

992G (7HR, ADZ),
994D (3TZ) WHEEL LOADER;
854G (1JW, AMP) WHEEL TRACTOR

Problem:

The diagnostic code MID 036 CID 0800 FMI 09 (VIMS main module - Abnormal Update) may be logged in the VIMS event list if all the following conditions are true and occur in this order:

* The operator moves the key start switch from the OFF position to the START position and waits for the VIMS to complete its self-test.
* The operator then cranks the engine.
* The operator then cranks the engine.

These conditions may cause the VIMS main module to self-test (reboot) again. While the VIMS main module is self-testing, the engine ECM is unable to communicate with the VIMS main module and may log the MID 036 CID 0800 FMI 09 Diagnostic event. VIMS will then temporarily display the event that is received from the engine ECM and also logs it in the VIMS event list.

Solution:

There is nothing wrong with the electronic control modules. The system voltage should not drop to the 12 to 14 volt range, this could indicate a problem exists with the machine's starting/charging system. The software that controls this event on the machine sees the loss of communication during the low voltage cranking as a problem, and generates the diagnostic event. This problem will be addressed in a future software release.

COPYRIGHT 2000 CATERPILLAR ALL RIGHTS RESERVED

Caterpillar Information System:

Grapple Chattering When The Grapple Is Lowered At Idle Or At Low Engine Speeds Grapple Chattering When The Grapple Is Lowered At Idle Or At Low Engine Speeds
Test Cell Oil Screen And Oil Filter Test Cell Oil Screen And Oil Filter
Misalignment Between The Engine And The Hydrostatic Pump May Be Caused By Missing Flywheel Housing Dowel Pins Misalignment Between The Engine And The Hydrostatic Pump May Be Caused By Missing Flywheel Housing Dowel Pins
Air Cleaner May Allow Moisture Ingress Air Cleaner May Allow Moisture Ingress
Hydraulically Actuated Electronically Controlled Unit Injector (HEUI) Hydraulic Pump Hydraulically Actuated Electronically Controlled Unit Injector (HEUI) Hydraulic Pump
Modification To The Spacer Plate For The Recoil Spring Modification To The Spacer Plate For The Recoil Spring
Transmission May Neutralize While Operating The Transmission Directional Switch Transmission May Neutralize While Operating The Transmission Directional Switch
Do Not Use 183-1908 Or 183-7404 Flash Files On Track-Type Tractors And Pipelayers Do Not Use 183-1908 Or 183-7404 Flash Files On Track-Type Tractors And Pipelayers
138-8361 Pivot Shaft Seal Guard Not Compatible With Certain D9R Track-Type Tractors 138-8361 Pivot Shaft Seal Guard Not Compatible With Certain D9R Track-Type Tractors
Machines Equipped With Third Implement Control Lever Machines Equipped With Third Implement Control Lever
Improvements To Bearing Used In Planetary Groups Improvements To Bearing Used In Planetary Groups
Brake Stop Light Switch Brake Stop Light Switch
VIMS May Reset When Loader Payload Data Is Downloaded With VIMSpc99 Or Accessed VIA The Loader Payload Menu VIMS May Reset When Loader Payload Data Is Downloaded With VIMSpc99 Or Accessed VIA The Loader Payload Menu
Requirements For 111-2427 Clip When Performing PS40125 Requirements For 111-2427 Clip When Performing PS40125
Field Returns Of Failed Actual Gear Position Sensors On D-Series Small Off-Highway Trucks, Wheel Tractor Scrapers, And Articulated Trucks Are Needed For failure Analysis Field Returns Of Failed Actual Gear Position Sensors On D-Series Small Off-Highway Trucks, Wheel Tractor Scrapers, And Articulated Trucks Are Needed For failure Analysis
131-4095 Tube Assembly May Lack Orifices 131-4095 Tube Assembly May Lack Orifices
Seats With Arm Rests Need Spacer Bars When The Seat Suspension Is Replaced Seats With Arm Rests Need Spacer Bars When The Seat Suspension Is Replaced
Transmission Controls (Shift Lever) May Fail Transmission Controls (Shift Lever) May Fail
Testing The Function Of The 3E6477 Relay Assembly (24 Volt) Testing The Function Of The 3E6477 Relay Assembly (24 Volt)
Debris From Manufacturing Operations Debris From Manufacturing Operations
Engine Continues To Run With Key Switch Off Engine Continues To Run With Key Switch Off
Failure Of The Friction Disc For The Joystick Hold Control Failure Of The Friction Disc For The Joystick Hold Control
Sand Blast Grid Sand Blast Grid
A New Battery Clip Is Now Used On The 980G Wheel Loader A New Battery Clip Is Now Used On The 980G Wheel Loader
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.