Operation Of 119-1733 And 134-1346 12-Volt Converters Caterpillar


Operation Of 119-1733 And 134-1346 12-Volt Converters

Usage:

GENERALALL 24 VOLT MACHINES EQUIPPED WITH 12 VOLT RADIOS

Problem:

Some 12-volt converters have been erroneously replaced. The specific complaint has been that the output voltage from the converter is too high (24 volts to 28 volts) when the radio is not connected to the converter and the keyswitch is turned to the "ON" position.

Solution:

The output voltage from the converter should only be checked under the following conditions: the radio is connected to the converter, the keyswitch is turned to the "ON" position, and the radio is turned "ON". When there is no electrical load connected to the converter, it is normal for the converter output voltage to measure between 11 volts and 28 volts. When the radio is turned on, the output voltage from the converter should measure between 11 volts and 14.5 volts.

COPYRIGHT 2000 CATERPILLAR ALL RIGHTS RESERVED

Caterpillar Information System:

Generator Circuit Breaker Mounting Bolts May Be Loose Generator Circuit Breaker Mounting Bolts May Be Loose
Exhaust Valve Recession Exhaust Valve Recession
Cylinder Block Bore Wear Cylinder Block Bore Wear
Remote Air Conditioner Condenser Repair Remote Air Conditioner Condenser Repair
Coolant Manifold Gasket Leaks On C-10 And C-12 Engines In Peterbilt Trucks Coolant Manifold Gasket Leaks On C-10 And C-12 Engines In Peterbilt Trucks
Turbocharger Mounting Studs Turbocharger Mounting Studs
EMCP NFPA 99 Ran Annunciator Modules Will Not Perform As Specified EMCP NFPA 99 Ran Annunciator Modules Will Not Perform As Specified
Hydrax Oil Supply And Return Tube Support Clip Failure Hydrax Oil Supply And Return Tube Support Clip Failure
Cylinder Block And Cylinder Liner Pitting Cylinder Block And Cylinder Liner Pitting
178-2439 Seal Assembly Not Currently Available In Parts 178-2439 Seal Assembly Not Currently Available In Parts
Temporary Spark Plug Substitute Temporary Spark Plug Substitute
Remanufactured Water Pump For 3500 Engine Remanufactured Water Pump For 3500 Engine
Restriction Port Indicator May Not Function Restriction Port Indicator May Not Function
Troubleshooting For Oil Carry Over From Side Mounted Breathers Troubleshooting For Oil Carry Over From Side Mounted Breathers
3300V/2400V Primary Taps Have Not Been Capped When The Third Transformer Is Installed For Use With EMCPII+ Control Panels 3300V/2400V Primary Taps Have Not Been Capped When The Third Transformer Is Installed For Use With EMCPII+ Control Panels
Installation Of The Top And The Intermediate Piston Rings On G3600 Engine Pistons Installation Of The Top And The Intermediate Piston Rings On G3600 Engine Pistons
Status Control Module (SCM) Problem Status Control Module (SCM) Problem
ADEM2000 Heavy Duty Truck Engine Speed Sensor Service ADEM2000 Heavy Duty Truck Engine Speed Sensor Service
Exhaust Gas Leakage At Cylinder Head To Manifold Connection Exhaust Gas Leakage At Cylinder Head To Manifold Connection
Excessive Oil Consumption On New Engines Excessive Oil Consumption On New Engines
Installation Of Pressure Limiting Circuit Installation Of Pressure Limiting Circuit
Seal Ring Seizes In Exhaust Coupling In Turbocharger Group Seal Ring Seizes In Exhaust Coupling In Turbocharger Group
Connecting Rod Bearings Connecting Rod Bearings
Hydraulically Actuated Electronically Controlled Unit Injector (HEUI) Hydraulic Pump Hydraulically Actuated Electronically Controlled Unit Injector (HEUI) Hydraulic Pump
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.