EMCP NFPA 99 Ran Annunciator Modules Will Not Perform As Specified Caterpillar


EMCP NFPA 99 Ran Annunciator Modules Will Not Perform As Specified

Usage:

ENGINES3306B (2MW, 8NS),
3406C (7MS, 9ES),
3406E (8AZ),
3412 (4BZ),
3456 (9BZ),
3508 (23Z, 3XS, 69Z, 7AK, 70Z, 96Y),
3508B (4PM, 7RN),
3512 (24Z, 3LS, 5XM, 50Y, 66Z, 67Z),
3512B (3NS, 4GM, 6GW, 6PN),
3516 (25Z, 29Z, 3MS, 4MJ, 4XF, 5SJ, 6PM, 72Z, 73Z),
3516B (4CR, 6HN, 8RM) All Generator Sets Equipped With EMCP II Control Panel And NFPA Ran Module

Problem:

The 130-3349 Annunciator Modules (with a 130-3329 Film) with date codes of 03 May 99 to 16 Aug 99 will not operate in RAN mode per the EMCP II/II+ Service Manual - Alarm Module "Mode Selection and Switch Input Connections" Chart.

Solution:

A new alarm module with a date code after the 16 Aug 99 will be needed in order to be used to operate in RAN mode. These same affected modules will however operate properly in the other five modes specified in the service manuals.

COPYRIGHT 1999 CATERPILLAR ALL RIGHTS RESERVED

Caterpillar Information System:

Hydrax Oil Supply And Return Tube Support Clip Failure Hydrax Oil Supply And Return Tube Support Clip Failure
Cylinder Block And Cylinder Liner Pitting Cylinder Block And Cylinder Liner Pitting
178-2439 Seal Assembly Not Currently Available In Parts 178-2439 Seal Assembly Not Currently Available In Parts
Temporary Spark Plug Substitute Temporary Spark Plug Substitute
Remanufactured Water Pump For 3500 Engine Remanufactured Water Pump For 3500 Engine
154-3730 Crankcase Breather Assembly 154-3730 Crankcase Breather Assembly
Test Procedure For Electrical Components Of Air Conditioning System Test Procedure For Electrical Components Of Air Conditioning System
Logged Service Codes Are Erased On Certain Monitoring System Modules When The Key Switch Is Turned Off Logged Service Codes Are Erased On Certain Monitoring System Modules When The Key Switch Is Turned Off
Torque Converter Turbine Rubbing And Wear Torque Converter Turbine Rubbing And Wear
Oil Pan Cracking Oil Pan Cracking
Alternate Procedure For Repairing Oil Leaks Around The Cam Roller Follower Side Covers Alternate Procedure For Repairing Oil Leaks Around The Cam Roller Follower Side Covers
Hydrax Actuator Shaft Protection Hydrax Actuator Shaft Protection
Turbocharger Mounting Studs Turbocharger Mounting Studs
Coolant Manifold Gasket Leaks On C-10 And C-12 Engines In Peterbilt Trucks Coolant Manifold Gasket Leaks On C-10 And C-12 Engines In Peterbilt Trucks
Remote Air Conditioner Condenser Repair Remote Air Conditioner Condenser Repair
Cylinder Block Bore Wear Cylinder Block Bore Wear
Exhaust Valve Recession Exhaust Valve Recession
Generator Circuit Breaker Mounting Bolts May Be Loose Generator Circuit Breaker Mounting Bolts May Be Loose
Operation Of 119-1733 And 134-1346 12-Volt Converters Operation Of 119-1733 And 134-1346 12-Volt Converters
Restriction Port Indicator May Not Function Restriction Port Indicator May Not Function
Troubleshooting For Oil Carry Over From Side Mounted Breathers Troubleshooting For Oil Carry Over From Side Mounted Breathers
3300V/2400V Primary Taps Have Not Been Capped When The Third Transformer Is Installed For Use With EMCPII+ Control Panels 3300V/2400V Primary Taps Have Not Been Capped When The Third Transformer Is Installed For Use With EMCPII+ Control Panels
Installation Of The Top And The Intermediate Piston Rings On G3600 Engine Pistons Installation Of The Top And The Intermediate Piston Rings On G3600 Engine Pistons
Status Control Module (SCM) Problem Status Control Module (SCM) Problem
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.