Adjustment of Steering Yoke Linkage
Usage:
1. Remove cotter pin and pin and remove rod assembly (16).
2. Loosen locknut (15). Make an adjustment to the rod so that distance (E) between flat surface of nut (14) and center of hole in rod (16), is ... 3.50 ± .03 in.(88.9 ± 0.8 mm)
3. Tighten locknut (15) to a torque of 75 ± 10 lb. ft. (100 ± 14 N·m) and install pin and cotter pin.
Caterpillar Information System:
D4E TRACTOR POWER TRAIN Adjustment of Steering Clutch Control Linkage
D4E TRACTOR POWER TRAIN Bevel Gear And Steering Clutch
D4E TRACTOR POWER TRAIN Bevel Pinion
D4E TRACTOR POWER TRAIN Steering Control Valves (Direct Drive)
D4E TRACTOR POWER TRAIN Transmission (Direct Drive)
D4E TRACTOR POWER TRAIN Oil Filter (Direct Drive) (3S7406)
D4E TRACTOR POWER TRAIN Oil Pump (Direct Drive) (5S1601)
D4E TRACTOR POWER TRAIN Adjustment Of Flywheel Clutch Interlock Linkage
D4E TRACTOR POWER TRAIN Adjustment Of Flywheel Clutch Control Linkage
D4E TRACTOR POWER TRAIN Drive Shaft (Direct Drive)
D4E TRACTOR POWER TRAIN Clutch Brake Adjustment
D4E TRACTOR POWER TRAIN Flywheel Clutch And Controls (Direct Drive)
D4E TRACTOR POWER TRAIN Adjustment Of Linkage Stop
D4E TRACTOR POWER TRAIN Adjustment Of Yoke Assemblies
D4E TRACTOR POWER TRAIN Adjustment Procedures For The Brakes
D4E TRACTOR POWER TRAIN Final Drive
D4E TRACTOR POWER TRAIN Adjustment Of Final Drive Bearings
D4E TRACTOR POWER TRAIN Equalizer Spring (4K5207)
D4E TRACTOR POWER TRAIN Case And Cover For The Steering Clutch
D4E TRACTOR POWER TRAIN Main Frame
D4E TRACTOR POWER TRAIN Drawbar Group (9H5806)
D4E TRACTOR POWER TRAIN Drawbar Group (9K8513)
D4E TRACTOR POWER TRAIN Alignment Of Track Roller Frame
D4E TRACTOR POWER TRAIN Track Rollers (Single and Double Flange)