914G WHEEL LOADER & IT14G INTEGRATED TOOLCARRIER HYDRAULIC S Caterpillar

NOTE: Coat all pin bores, including lift and tilt cylinders and the bucket, with lubricant. Lubricate the lip of all seals with lubricant being sealed.

NOTE: Install washers, as required at gap A, between lift arm and frame to center lift arm assembly between bosses on non-engine end. The maximum total gap at any one location is 1.8 mm (.071 in).

2G-5672 Washer thickness (new) ... 1.6 mm (.063 in)

6K-2274 Washer thickness (new) ... 3.0 mm (.118 in)

NOTE: Use washers as required at gap B to center bucket in the lift arm assembly. The maximum total gap at any one location is 1.8 mm (.071 in).

5G-2318 Washer thickness (new) ... 1.6 mm (.063 in)

6S-3461 Washer thickness (new) ... 3.0 mm (.118 in)