3406C DIESEL TRUCK ENGINE Caterpillar


Governor Control Linkage

Usage:


(1) Clearance on both sides of tang. (2) Governor control linkage. (3) pedal (full travel). (4) Governor control. (5) Lever assembly.

Linkage Adjustment

1. Push accelerator pedal (3) down against its stop.

2. Adjust linkage between lever assembly (5) and the accelerator pedal until there is clearance on both sides of the tang (1) in lever assembly.

3. Check the linkage adjustment, push the pedal (3) down against the stop. If the linkage adjustment is correct, the governor linkage (2) will move to the break-over position when the pedal is against the stop. This is shown by clearance on both sides of the tang, the governor linkage (2) is adjusted correctly to permit the engine to operate at high idle.

Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.