3406C (PEEC III) DIESEL TRUCK ENGINE Caterpillar


3.0 Troubleshooting without a Diagnostic Code

Usage:

NOTE: Before using this section, be sure that you have:

1. Gathered information about the complaint to adequately describe the symptoms.

2. Verified that the complaint is not due to normal engine operation.

3. Repaired all ACTIVE Diagnostic Codes.

Then, identify probable causes using the procedure in this section which best describes the symptoms. Then narrow the probable causes using:

Driver Information

What happened, and when?

Under what conditions?

What else occurred?

When did the symptoms begin (and what else happened at that time)?

LOGGED Diagnostic Codes

Do they correlate to probable causes?

Did they occur at the same time as the symptoms?

Are some logged repeatedly?

Other Symptoms

Are they related to this symptom?

Do they have common probable causes?

Finally, test each probable cause using the tests suggested by the procedure. Be sure to check connectors, especially on intermittent problems!

Caterpillar Information System:

3406C (PEEC III) DIESEL TRUCK ENGINE 2.0 Programming Parameters
3406C (PEEC III) DIESEL TRUCK ENGINE 1.0 PEEC III Electronic System Overview
SUPPLEMENT FOR - 3176 REAR POWER TAKE-OFF (RPTO) Rear Power Take-Off (RPTO)
SUPPLEMENT FOR - 3176 REAR POWER TAKE-OFF (RPTO) Testing And Adjusting
SUPPLEMENT FOR - 3176 REAR POWER TAKE-OFF (RPTO) Systems Operation
SUPPLEMENT FOR - 3176 REAR POWER TAKE-OFF (RPTO) Rear Power Take-Off Gear Group (RPTO)
ELECTRONIC MODULAR CONTROL PANEL II (EMCP II) Schematics & Wiring Diagrams
ELECTRONIC MODULAR CONTROL PANEL II (EMCP II) Testing And Adjusting
ELECTRONIC MODULAR CONTROL PANEL II (EMCP II) Systems Operation
ELECTRONIC MODULAR CONTROL PANEL (EMCP) FOR RENTAL GENERATOR Schematics & Wiring Diagrams
ELECTRONIC MODULAR CONTROL PANEL (EMCP) FOR RENTAL GENERATOR Testing And Adjusting
ELECTRONIC MODULAR CONTROL PANEL (EMCP) FOR RENTAL GENERATOR Systems Operation
3406C (PEEC III) DIESEL TRUCK ENGINE 4.0 Troubleshooting with a Diagnostic Code
3406C (PEEC III) DIESEL TRUCK ENGINE 5.0 Electronic Subsystem Functional Tests
3406C (PEEC III) DIESEL TRUCK ENGINE 6.0 Glossary Of PEEC III Terms
3406C Electronic Diesel Truck Engine Electrical System 3406C Electronic Diesel Truck Engine Electrical System
3406C (PEEC III) TRUCK ENGINE Introduction
3406C (PEEC III) TRUCK ENGINE Tools Required
3406C (PEEC III) TRUCK ENGINE Test Procedure
3406C (PEEC III) TRUCK ENGINE 3406C (PEEC III) Truck System Tests Not Covered by the Volt-Ohm Meter
3406C (PEEC III) TRUCK ENGINE Correct Adjustment of the Throttle Linkages
3406C (PEEC III) TRUCK ENGINE Responsibility for Throttle Pedal Adjustment
3406C (PEEC III) TRUCK ENGINE Visual Inspection and Repair of Connectors
3406C (PEEC III) TRUCK ENGINE Correct Wiring of Vehicle Speed Sensor
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.