Usage:
(1) Output shaft. Diameter of output shaft (A) is ... 60.245 ± .025 mm (2.3718 ± .0010 in)
(2) Carrier assembly. The bearing in carrier assembly is installed to a depth (B) of ... 1.6 ± 0.5 mm (.06 ± .02 in)
(3) Install bearings with split at the 7 o'clock position when viewed from the rear of the engine.
(4) Power take-off gear. Inside diameter of power take-off drive gear ... 60.320 ± .025 mm (2.3748 ± .0010 in)
The clearance between the output shaft (1) and the power take-off gear (4) is ... .025 to .125 mm (.001 to .005 in)
(5) Install bearings with split at the 7 o'clock position when viewed from the rear of the engine.
(6) Thickness of thrust washer:
4P4181 ... 4.690 ± .025 mm (.1846 ± .0010 in)
(7) Thickness of thrust washer:
4P4178 ... 4.690 ± .025 mm (.1846 ± .0010 in)
Endplay of output shaft (1) is ... 0.97 ± 0.43 mm (.038 ± .017 in)
(8) Thickness of thrust plate is ... 6.75 mm (.266 in)
(10) Seal must be installed to a depth of ... 2.5 ± 0.5 mm (.100 ± .02 in)
(9) Idler gear assembly. The bearing must not extend beyond either face. Relief (11) in bearing to line up with reliefs in gear within 2 degrees.