Usage:
START BY:
a. remove valve cover (later)
1. Remove bolt (1) and retainer (2).
2. Remove fuel injection nozzle assembly (3) with tool (A).
3. Use tool (B) to clean the fuel injection nozzle bore. Use an open wrench or tap driver to turn tool (B).
NOTE: The fuel injection nozzle is serviced as an assembly only.
Install Fuel Injection Nozzles (New Scroll Fuel System Effective In Production With 10X5411-UP, 45V36536-UP)
| NOTICE |
|---|
Before the fuel injection nozzles are installed, check for fuel leakage, the pressure at which the injection nozzle opens, and the amount of fuel (spray pattern) that comes out of the nozzle with tool (A). See Testing Fuel Injection Nozzles in Testing And Adjusting. |
1. Install washer (compression seal) (1), and use tool (B) to install carbon dam seal (2) on the fuel injection nozzle.
2. Install fuel injection nozzles (3) in the cylinder head.
3. Install retainer (4) and the bolt.
END BY:
a. install valve cover (later)