Usage:
1. Tip the blade forward as shown.
2. Fasten a hoist to tip cylinder (2). Put identification on two hose assemblies (5) and disconnect them.
3. Remove bolt (3) and pin (4). Remove cotter pin, pin (1), and spacers from the opposite end of tip cylinder (2). Remove tip cylinder (2).
4. Install tool (A) and fasten a hoist.
5. Remove four bolts (7) and cap (8). Remove the shims from between bracket assembly (6) and cap (8).
6. Remove cotter pin (10), nut (9), and the washer. Remove shaft (11) and washers (12).
7. Remove the blade assembly. The weight is 888 Kg (1960 lbs.).
NOTE: The following steps are for installation of the blade assembly.
8. Install tool (A) and fasten a hoist to the blade assembly.
9. Put the blade assembly in position under the machine.
10. Install shaft (11) and washers (12). Install washer and nut (9). Tighten nut (9) to zero clearance and back off one slot. Install cotter pin (10).
11. Install shims between bracket assembly (6) and cap (8). Install bolts (7).
12. Fasten a hoist to tip cylinder (2). Put tip cylinder (2) in position. Install pin (1), spacers, and cotter pin. Install pin (4) and bolt (3). Connect hose assemblies (5).