Usage:
Start By:
a. remove BrakeSaver control valve
1. Disconnect oil line (1) from the left side of the oil pan.
2. Remove bolts (2) that hold the oil pan to the cylinder block. Remove oil pan (3) from the cylinder block.
3. Remove baffle assembly (4) and the O-ring seal from the oil pan.
4. Remove tube assembly (5) an the O-ring seal from the oil pan.
5. Thoroughly remove the old gasket from the cylinder block and oil pan.
NOTE: The following steps are for installation of the oil pan.
6. Inspect the O-ring seals for damage, and make replacements if needed. Put clean engine oil on the O-ring seals.
7. Install the O-ring seal and tube assembly (5) in the oil pan.
8. Install the O-ring seal and baffle assembly (4) in the oil pan.
9. Install two 3/8" - 16 NC guide bolts on each side of the cylinder block. Put oil pan (3) in place under the cylinder block. Make sure the BrakeSaver oil supply tube is in alignment with the hole in the oil pan.
10. Install bolts (2) that hold the oil pan in place.
11. Connect oil line (1) to the left side of the oil pan.
End By:
a. install BrakeSaver control valve