Usage:
START BY:
a. install body retaining pins
1. Remove two bolts (2) and the clamps that fasten two grease hoses (1) to the frame.
2. Remove bolt (5) and nut and two washers (4) from each end of stabilizer rod (3).
3. Use tool (A) to remove pin (6) that fastens each end of the stabilizer rod to the frame and axle housing.
4. Remove three nuts (7), bolts and lockwashers from each end of the stabilizer rod, and remove two retainers (9) from each end of the rod.
5. Use a press and tooling (B) to remove bearing assembly (8) from each end of the stabilizer rod.
6. Use a press and tooling (B) to install the bearing assembly in each end of the stabilizer rod.
7. Install retainer (9) on each side of each end of the rod with three nuts (7), bolts and lockwashers.
8. Put the stabilizer rod in position, and install pin (6) in each end of the rod.
9. Put washer (4) on each side of the pin, and install bolt (5), nut and lockwasher that hold the pin in position.
10. Put grease hoses (1) in position, and install two bolts (2) that fasten the hose clamps to the frame.
11. See Maintenance Guide for correct lubrication of bearings (9).
END BY:
a. remove body retaining pins