Usage:
start by:
a) remove cylinder heads
1. Remove water seals (1).
2. Remove O-ring seal (2).
3. Remove bolts (3).
4. Install six 3/8"-16 NC forcing screws in the spacer plate. Use the forcing screws to remove the spacer plate (4) from the engine block evenly. Remove gasket.
5. Remove O-ring seal (5) from the engine block.
Install Spacer Plates
1. Thoroughly clean the spacer plate and the surface of the cylinder block.
| NOTICE |
|---|
The surfaces of the spacer plate and cylinder block and both sides of spacer plate gasket must be clean and dry. Do not put liquid gasket or any other material on these surfaces. |
2. Install a new O-ring seal (1) on the engine block.
3. Put a new gasket (3) in position on the engine block.
4. Put spacer plate (2) in position over the gasket.
5. Install the bolts (4) and tighten them to a torque of 35 ± 5 lb.ft. (45 ± 7 N·m).
6. Install water seals (5) and O-ring seal (6).
7. Check cylinder liner projection. See INSTALL CYLINDER LINERS.
end by:
a) install cylinder heads