D330, D333, 3304, 3306 INDUSTRIAL & MARINE ENGINES Caterpillar


Camshaft Bearings

Usage:

Remove Camshaft Bearings

start by:

a) remove camshaft

b) remove flywheel housing

1. Remove the camshaft bearings with tool group (A) starting with the front bearing.

Install Camshaft Bearings

1. Install the camshaft bearings in the cylinder block with tool group (A) starting with the front bearing. Install all bearings with oil hole in bearing in alignment with the oil hole in the cylinder block.

2. The front and rear bearings must be inside the face of the cylinder block .06 ± .02 in. (1.5 ± 0.5 mm) from their respective ends of the cylinder block after installation.

end by:

a) install flywheel housing

b) install camshaft

Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.