Usage:
start by:
a) remove starter
b) remove flywheel
1. Loosen the bolts that hold the oil pan to the cylinder block. Remove the bolts that hold the oil pan to the flywheel housing. Fasten a hoist to the rear of the engine. Life the rear of the engine and install shims on each side of the cylinder block.
2. Remove the bolts (2) and locks that hold the flywheel housing in place. Remove flywheel housing (1).
Install Flywheel Housing
1. Clean the contact surfaces of the flywheel housing and cylinder block. Install a new gasket.
2. Put oil on the lip of the rear seal. Put flywheel housing in position and install the locks and bolts.
3. Cut the gasket so it is even with the bottom of the block and flywheel housing. Remove the shims from each side of the block and tighten the bolts for the oil pan. Install remainder of bolts in the oil pan.
4. Install the starter.
end by:
a) install flywheel