Fuel Injection Lines
Usage:
Remove And Install Fuel Injection Lines
1. Thoroughly clean the area around each fuel line connection before the removal of any fuel lines.
2. Disconnect fuel lines (1) at the fuel injection pump and at cylinder heads (4). Disconnect fuel lines at fuel injection block (2) and at fuel filter base (3). Remove the nut that holds fuel injection line to the inlet manifold. Remove the fuel injection lines.
3. Put caps on all openings and plugs in all fuel lines to keep dirt or foreign material out of the fuel system.
4. Remove the plugs and caps and install the fuel lines in their respective positions. Tighten fuel line nuts to a torque of 30 ± 5 lb. ft. (40 ± 7 N·m).
5. Remove (bleed) the air from the fuel system.
Caterpillar Information System:
3208 TRUCK ENGINE Air Cleaner
3208 TRUCK ENGINE General Instructions
3208 TRUCK ENGINE Engine Vibration Troubleshooting
3208 TRUCK ENGINE Fuel In Crankcase Oil
3208 TRUCK ENGINE Loss Of Coolant
3208 TRUCK ENGINE Cooling System
3208 TRUCK ENGINE Difficult Starting
3208 TRUCK ENGINE Too Much Exhaust Smoke
3208 TRUCK ENGINE Misfiring And Running Rough
3208 TRUCK ENGINE Problem With Vehicle Or Vehicle Operation
3208 TRUCK ENGINE High Fuel Consumption Troubleshooting
3208 TRUCK ENGINE Primary Engine Test For High Fuel Consumption
3208 TRUCK ENGINE Air Inlet Manifold
3208 TRUCK ENGINE Fuel Injection Pump Housing And Governor
3208 TRUCK ENGINE Check Valve And Bypass Valve
3208 TRUCK ENGINE Shutoff Housing
3208 TRUCK ENGINE Fuel Injection Pumps
3208 TRUCK ENGINE Fuel Transfer Pump
3208 TRUCK ENGINE Fuel Injection Pump Housing And Governor
3208 TRUCK ENGINE Governor
3208 TRUCK ENGINE Fuel Injection Pump Housing
3208 TRUCK ENGINE Fuel Injection Pump Housing (With Thrust Washer)
3208 TRUCK ENGINE Exhaust Manifold
3208 TRUCK ENGINE Starter