Flywheel
Usage:
(1) Flywheel shoulder.
(2) Install ring gear so that Part No. is on this side. Ring gear must be assembled against shoulder of flywheel.
NOTE: Do not heat ring gear to more than 400°F (204°C) before installing on flywheel.
(3) Pilot bore.
(4) Torque for bolts that hold flywheel to crankshaft ... 65 ± 5 lb.ft.(90 ± 7 N·m)
Put 5P3413 Sealant on bolt threads.
NOTE: Dash mark on flywheel must be in alignment with dash mark on crankshaft.
Caterpillar Information System:
3208 TRUCK ENGINE Fan Mounting Pulley Assemblies
3208 TRUCK ENGINE Pulley And Damper
3208 TRUCK ENGINE Crankshaft
3208 TRUCK ENGINE Bearings For Connecting Rods And Mains
3208 TRUCK ENGINE Pistons And Rings
3208 TRUCK ENGINE Connecting Rod
3208 TRUCK ENGINE Cylinder Block
3208 TRUCK ENGINE V-Belt Tension Chart
3208 TRUCK ENGINE Water Temperature Regulator (9N5121)
3208 TRUCK ENGINE Water Pump
3208 TRUCK ENGINE Oil Level Gauge
3208 TRUCK ENGINE Oil Pump (With belleville washer bypass valve)
3208 TRUCK ENGINE Mounting Group For AT540, MT643, And MT653 Allison Transmission
3208 TRUCK ENGINE Flywheel Runout
3208 TRUCK ENGINE Flywheel Housing Runout
3208 TRUCK ENGINE Flywheel Housing Bore
3208 TRUCK ENGINE Alternators
3208 TRUCK ENGINE Electric Starter Motors
3208 TRUCK ENGINE Starter Solenoids
3208 TRUCK ENGINE Shutoff Solenoid
3208 TRUCK ENGINE Air Compressor
3208 TRUCK ENGINE System Operation
3208 TRUCK ENGINE Testing And Adjusting
3208 TRUCK ENGINE Introduction To The Troubleshooting Guide