Electric Starting Motor
Usage:
Remove Electric Starting Motor
1. Disconnect the wires from starting motor. Put identification on wires so they will not be mixed at installation.
2. Fasten a hoist to starter. Remove the three bolts (1) that hold starting motor to flywheel housing. Remove the electric starting motor. Weight is 70 lb. (32 kg).
Install Electric Starting Motor
1. Fasten a hoist and install electric starting motor on engine. Install the three bolts that hold starting motor to flywheel housing.
2. Connect the wires to their correct location on starting motor.
Caterpillar Information System:
3406 INDUSTRIAL & MARINE ENGINES Instrument Panel
3406 INDUSTRIAL & MARINE ENGINES Rear Support
3406 INDUSTRIAL & MARINE ENGINES Engine Front Support
3406 INDUSTRIAL & MARINE ENGINES Introduction
3406 INDUSTRIAL & MARINE ENGINES General Instructions
3406 INDUSTRIAL & MARINE ENGINES Introduction
3406 INDUSTRIAL & MARINE ENGINES Testing And Adjusting
3406 INDUSTRIAL & MARINE ENGINES Attachment Systems Operation
3406 INDUSTRIAL & MARINE ENGINES Shut-Off Solenoids
3406 INDUSTRIAL & MARINE ENGINES Starter Solenoid
3406 INDUSTRIAL & MARINE ENGINES Starter Motors
3406 INDUSTRIAL & MARINE ENGINES Oil Pressure Switch
3406 INDUSTRIAL & MARINE ENGINES Fuel Priming Pump
3406 INDUSTRIAL & MARINE ENGINES Fuel Filter Base
3406 INDUSTRIAL & MARINE ENGINES Sea Water Pump
3406 INDUSTRIAL & MARINE ENGINES Accessory Drive
3406 INDUSTRIAL & MARINE ENGINES Service Meter
3406 INDUSTRIAL & MARINE ENGINES Tachometer Drive
3406 INDUSTRIAL & MARINE ENGINES Fuel Transfer Pump
3406 INDUSTRIAL & MARINE ENGINES Fuel Transfer Pump (Earlier)
3406 INDUSTRIAL & MARINE ENGINES Fuel Transfer Pump (Later)
3406 INDUSTRIAL & MARINE ENGINES Automatic Timing Advance (Earlier)
3406 INDUSTRIAL & MARINE ENGINES Automatic Timing Advance (Later)
3406 INDUSTRIAL & MARINE ENGINES Automatic Timing Advance