Usage:
NOTE: Any adjustment to the governor must be made only by a person approved by Caterpillar or a Caterpillar Dealer.
(1) Torque for nut ... 9 ± 3 lb. ft.(12 ± 4 N·m)
(2) Torque for insulator ... 40 ± 5 lb. in.(4.5 ± 0.5 N·m)
(5) Governor Spring:
INSTALL SPRING WASHERS AS SHOWN
(6) Diameter of the outer surface of the cylinder (new) ... 1.2172 ± .0005 in.(30.917 ± 0.013 mm)
Bore in the gear (new) ... 1.2192 ± .0005 in.(30.968 ± 0.013 mm)
(7) Bore in the bearings (new) ... .6230 ± .0005 in.(15.824 ± 0.013 mm)
Diameter of the shaft (new) ... .6189 ± .0003 in.(15.720 ± 0.008 mm)
(8) Distance between the bearings for the governor control shaft ... 2.385 ± .005 in.(60.58 ± 0.13 mm)
(9) Distance from the face of the housing to the end of the bearing for the governor control shaft ... 1.708 ± .006 in.(43.38 ± 0.15 mm)
Dashpot (3% Regulation)
NOTE: Any adjustment to the governor must be made only by a person approved by Caterpillar or a Caterpillar Dealer.
(1) Torque for nut ... 9 ± 3 lb. ft.(12 ± 4 N·m)
(2) Torque for insulator ... 40 ± 5 lb. in.(4.5 ± 0.5 N·m)
(5) Governor Springs:
(5) Governor Springs (con't):
(6) Diameter of the outer surface of the cylinder (new) ... 1.2172 ± .0005 in.(30.917 ± 0.013 mm)
Bore in the gear (new) ... 1.2192 ± .0005 in.(30.968 ± 0.013 mm)
(7) Bore in the bearings (new) ... .6230 ± .0005 in.(15.824 ± 0.013 mm)
Diameter of the shaft (new) ... .6189 ± .0003 in.(15.720 ± 0.008 mm)
(8) Distance between the bearings for the governor control shaft ... 2.385 ± .005 in.(60.58 ± 0.13 mm)
(9) Distance from the face of the housing to the end of the bearing for the governor control shaft ... 1.708 ± .006 in.(43.38 ± 0.15 mm)