Pistons
Usage:
Disassemble Pistons
start by:
a) remove pistons
1. Remove retaining rings (2) for the piston pin.
2. Remove piston pin and remove piston (1) from connecting rod (3).
3. Remove piston rings with tool (A).
Assemble Pistons
1. Install piston rings (1) with tool (A).
NOTE: The two compression rings have marks "UP-1N" and "UP-2M". The rings must be installed with the marks toward the top of the piston with "UP-1N" being the top ring. Put the ring gaps in place 120° from each other.
2. Put clean oil on the piston pin. Put the piston in place on the connecting rod. The "V" mark on piston must be on the same side of rod as bearing notches (2) in connecting rod. Install the piston pin and retaining rings.
end by:
a) install pistons
Caterpillar Information System:
D353 INDUSTRIAL & MARINE ENGINES Pistons (Later)
D353 INDUSTRIAL & MARINE ENGINES Pistons (Earlier)
D353 INDUSTRIAL & MARINE ENGINES Camshaft Bearings
D353 INDUSTRIAL & MARINE ENGINES Camshaft
D353 INDUSTRIAL & MARINE ENGINES Water Directors
D353 INDUSTRIAL & MARINE ENGINES Valve Guides
D353 INDUSTRIAL & MARINE ENGINES Valve Seat Inserts
D353 INDUSTRIAL & MARINE ENGINES Valves
D353 INDUSTRIAL & MARINE ENGINES Valve Lifters
D353 INDUSTRIAL & MARINE ENGINES Spacer Plate
D353 INDUSTRIAL & MARINE ENGINES Cylinder Head Assembly (Later)
D353 INDUSTRIAL & MARINE ENGINES Cylinder Head Assembly (Earlier)
D353 INDUSTRIAL & MARINE ENGINES Cylinders Liners (Earlier)
D353 INDUSTRIAL & MARINE ENGINES Cylinder Liners (Later)
D353 INDUSTRIAL & MARINE ENGINES Vibration Damper And Pulley
D353 INDUSTRIAL & MARINE ENGINES Front Cover
D353 INDUSTRIAL & MARINE ENGINES Crankshaft Front Seal
D353 INDUSTRIAL & MARINE ENGINES Flywheel
D353 INDUSTRIAL & MARINE ENGINES Crankshaft Rear Seal
D353 INDUSTRIAL & MARINE ENGINES Flywheel Housing
D353 INDUSTRIAL & MARINE ENGINES Timing Gears
D353 INDUSTRIAL & MARINE ENGINES Timing Gear Housing
D353 INDUSTRIAL & MARINE ENGINES Crankshaft
D353 INDUSTRIAL & MARINE ENGINES 7231 Marine Transmission Systems Operation