Alternator
Usage:
Remove Alternator
1. Disconnect the wiring from alternator.
2. Loosen bolts (1) and remove bolt (2) from alternator.
3. Remove the belt from the pulley.
4. Remove the bolts that hold alternator.
5. Remove alternator from engine.
Install Alternator
1. Put the alternator in position on the engine.
2. Install the bolts for the alternator.
3. Put belt in position on pulley and tighten the bolts holding the alternator.
NOTE: For correct belt tension, See V-Belt Tension Chart in SPECIFICATIONS.
4. Connect the wiring to the alternator.
Caterpillar Information System:
D353 INDUSTRIAL & MARINE ENGINES Attachments Testing And Adjusting
D353 INDUSTRIAL & MARINE ENGINES Systems Operation
D353 INDUSTRIAL & MARINE ENGINES Auxiliary Water Pump (3N6937)
D353 INDUSTRIAL & MARINE ENGINES Raw Water Pump (2N2407)
D353 INDUSTRIAL & MARINE ENGINES Enclosed Clutches
D353 INDUSTRIAL & MARINE ENGINES Mechanical Gauges For Water Temperature
D353 INDUSTRIAL & MARINE ENGINES Mechanical Gauges For Oil Pressure
D353 INDUSTRIAL & MARINE ENGINES Sending Unit For Water Temperature
D353 INDUSTRIAL & MARINE ENGINES Sending Units For Oil Pressure
D353 INDUSTRIAL & MARINE ENGINES Shutoff Valve For Water Temperature
D353 INDUSTRIAL & MARINE ENGINES Contactor Switch For Water Temperature
D353 INDUSTRIAL & MARINE ENGINES Contactor Switch For Overspeed
D353 INDUSTRIAL & MARINE ENGINES Starter
D353 INDUSTRIAL & MARINE ENGINES Generator
D353 INDUSTRIAL & MARINE ENGINES Radiator
D353 INDUSTRIAL & MARINE ENGINES Fan Drive
D353 INDUSTRIAL & MARINE ENGINES General Instructions
D353 INDUSTRIAL & MARINE ENGINES Fuel Priming Pump
D353 INDUSTRIAL & MARINE ENGINES Fuel Priming Pump
D353 INDUSTRIAL & MARINE ENGINES Fuel Transfer Pump
D353 INDUSTRIAL & MARINE ENGINES Fuel Transfer Pump Adapter Housing
D353 INDUSTRIAL & MARINE ENGINES Fuel Injection Pump Housing
D353 INDUSTRIAL & MARINE ENGINES Fuel Ratio Control
D353 INDUSTRIAL & MARINE ENGINES Governor (Earlier)