Usage:
start by:
a) remove crankshaft pulley
1. Remove the front seal with tool group (A).
Install Crankshaft Front Seal
1. Put 7F2770 Cement on the outer metal surface of the front seal. Put the seal in position on the short end of the installer assembly (A). The lip of the seal must be toward the inside of the engine.
NOTE: If a new wear surface for the front seal is needed, put the spacer from tooling (A) between the seal and flange of the installer assembly.
2. Put the seal and installer assembly in position on the end of the crankshaft. Install bolt (1) and washer (2) that hold the crankshaft pulley in place. Tighten the bolt until the installer assembly makes contact with the crankshaft gear. Remove the bolt, washer and tool (A).
end by:
a) install crankshaft pulley