Usage:
start by:
a) remove fuel injection pumps
b) separation of governor from fuel injection pump housing
c) remove fuel transfer pump
1. Loosen the screws that hold the levers to the shaft assembly.
2. Remove the screw (1) that holds the lever assembly (2) to the shaft assembly.
3. Remove the shaft asembly (5) from the housing and remove the levers (3) and lever assembly (2).
4. Loosen the screws that hold the levers (6) to the shaft.
5. Remove the screw that holds the lever (4) to the shaft.
6. Remove the shaft (7) from the housing and remove the levers.
7. Remove the lifter and roller assemblies (8) from the housing with a magnet.
NOTE: Put identification on the lifters (10) and rollers (9) for installation in their respective bores in the housing.
8. Remove the camshaft (11) from the housing.
| NOTICE |
|---|
Do not use a force to remove the camshaft. Turn the camshaft to permit the free passage of the camshaft by the bosses (12) in the housing. |
Assemble Fuel Injection Pump Housing
1. Install the camshaft (1) in the housing.
| NOTICE |
|---|
Do not use a force to install the camshaft. Turn the camshaft to permit the free passage of the camshaft by the bosses in the housing. |
2. Install the lifter and roller assemblies (2) in their respective bores in the housing with a magnet.
NOTE: Install the lifters with their grooves in alignment with the pins (3) in the housing.
3. Put the shaft (4) in the housing. Slide the levers (6) and the lever (5) on to the shaft in the order shown. Push the shaft into position in the housing.
4. Install the screw that holds the lever (5) to the shaft. Tighten the screw to a torque of 24 ± 2 lb. in. (2.71 ± 0.23 N·m).
NOTE: Use 5P7253 Socket Assembly to tighten the screw.
5. Put the shaft assembly (7) in the housing. Slide the levers (9) and the lever assembly (8) on to the shaft in the order shown. Push the shaft assembly into position in the housing.
6. Install the screw that holds the lever assembly (8) to the shaft assembly. Tighten the screw to a torque of 24 ± 2 lb. in. (2.71 ± 0.23 N·m).
NOTE: Use 5P7253 Socket Assembly to tighten the screw.
end by:
a) make adjustments to the sleeve control shafts (see TESTING AND ADJUSTING)
b) install fuel transfer pump
c) connection of governor to fuel injection pump housing
d) install fuel injection pumps