3208 TRUCK ENGINE Caterpillar


Flywheel Housing Runout

Usage:


8S2328 DIAL INDICATOR GROUP INSTALLED

Face Runout (axial eccentricity) of the Flywheel Housing:

1. Fasten a dial indicator to the crankshaft flange so the anvil of the indicator will touch the face of the flywheel housing.

2. Put a force on the crankshaft toward the rear before reading the indicator at each point.

3. With dial indicator set at .000 in. (0.0 mm) at location (A), turn the crankshaft and read the indicator at locations (B), (C) and (D).

4. The difference between lower and higher measurements taken at all four points must not be more than .008 in. (0.20 mm), which is the maximum permissible face run out (axial eccentricity) of the flywheel housing.

Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.