Usage:
start by:
a) remove fuel injection pump housing and governor
b) remove fuel shutoff solenoid
c) remove fuel ratio control
d) remove tachometer drive
1. Remove adapter housing (1) and the gasket from the governor housing.
2. Remove shaft (5), lever assembly (4) and lever (3) from the adapter housing. Remove seal (2) from the adapter housing.
3. Remove control lever (7) and spring (6).
4. Remove base (8) and the gasket from the governor housing.
Install Adapter Housing And Levers
1. Install base (1) with a gasket on the governor housing.
2. Install spring (2) and control lever (3).
NOTE: The bottom end of spring (2) must be turned (wound) 11/4 turns clockwise to get a preload on the spring.
3. Check the distance between the governor housing and the inside of lever (3). The distance must be .437 in. (11.10 mm) with the shaft pushed in against the governor housing.
4. Install the seal in the adapter housing. Install the lever, lever assembly and shaft in the adapter housing.
5. Install the seal and adapter housing on the base.
end by:
a) install fuel ratio control
b) install fuel shutoff solenoid
c) install tachometer drive
d) install fuel injection pump housing and governor