Turbocharger Nozzle Cleaning{1052}
Usage:
All 3600 Diesel Engines
This article replaces the article with the same title on Page 10 of the January 1996 issue of Engine News.
A more effective method of cleaning the turbocharger nozzles and turbine wheels has recently been found. Place the turbocharger nozzle and turbine wheel in agitated water for 16 to 24 hours. Remove the nozzle and wheel from the water and blow dry with compressed air. No chemicals or solvents work better than just plain water.
Caterpillar Information System:
1996/06/12 Start-Up Procedure After Rebuild{1000}
1996/06/12 New Part Kits Available For SR4B Generators{4469}
1996/06/12 Selection Of Service Harness For Engines With Electronic Ignition System{1408}
1996/06/12 Higher Capacity Oil Pump Used{1304}
1996/06/12 New Personality Modules For 3412 Generator Set Engines{1902}
1996/06/12 Incorrect Full Torque Setting Values Displayed On Engine Information Tags{1901}
1996/06/12 New O-Ring Seal Improves Engine Initial Combustion Gas Sealing{1290}
1996/06/12 New Woodward Governor PSG Groups Improve Engine Stabability{1264,1265}
1996/06/12 Improved Governor Servo Components Available For Use With Energize To Run Solenoids; Energize To Run Solenoid Stop Bolt Adjustment Procedure{1264,1259}
1996/06/12 Be Sure To Use Correct Stainless Steel Sleeve In Exhaust Ports{1059}
1996/06/12 Formed Rubber Hose Replaces Cast Iron Elbow In Radiator Groups; Be Sure To Use The Correct Water Temperature Regulator{1353}
1996/06/12 Troubleshooting Information{7569}
1996/06/12 Improvements To Check Valve Within Prechamber Group Reduce Maintenance Schedule{1106}
1996/06/12 New Components In Accessory Drive Group And Alternator Drive Group Provide Improved Serviceability And Help Prevent Oil Leaks{1207,1425}
1996/06/12 New Hose Assembly And Clip Replaces Former Tube Assembly{1318}
1996/06/12 Preventive Measure For Protection Of Air Prelube Pumps{1319}
1996/06/12 Field Installation Procedure For Stator Thermocouples and RTDs{7498,4453}
1996/06/12 New Oil Pump Used As Service Replacement{3310}
1996/07/22 New Bench Checking And Setting Procedure For Fuel Ratio Control (FRC) Mechanical Goverened Engines{1264,1265}
1996/07/22 New Service Tool Calibration Pins For Mechanical Goverened Engines{1264,1265}
1996/07/22 Governor Shimming Is Determined By The Governor Test Bench Calibration{1264,1289}
1996/07/22 Replacing The Shutoff Assembly In Engines With Older Governors{1264,1289}
1996/07/22 Servo Assembly Parts Have Been Changed To Make Some Parts Common Between Mechanical Governed (Type I-VI) Engines{1264,1289}
1996/07/22 New Electroless Nickel-Plated Oil Pan Provides Corrosion Protection{1302}