Inspection Of Oil Filters In Parts Stocks
Usage:
3204, 3208 Engines In All Applications
Some oil filters that we had in parts stock for 3204 and 3208 Engines have preload springs with a low spring rate. These filters are not acceptable for parts service. Because of this, some dealers could not get enough filters for a short period of time. Our dealers were notified of this situation and instructed as to how these filters could be identified.
Caterpillar Information System:
1979/04/25 New Oil Cooler Bonnets Used On 3408 And 3412 Engines
1979/04/25 How To Extend The Service Life Of 1P5550 Fuel Cam Locking Tool Assembly
1979/04/25 Inspection Of Oil Pump After Long Periods Of Service Can Prevent Engine Damage
1979/04/25 Careful, Correct Installation And Maintenance Of Fuel Injection Lines Is Very Important To Prevent Possible Engine Damage, Fire And Other Problems
1979/04/25 Conversion Group Available To Install Woodward Governor On Engines Equipped With Mechanical Governor
1979/04/25 Inspection Of Connecting Rods In Parts Stocks
1979/04/25 6V112 Repair Kit Available For Parts Service Of The 8H8558 Nut Spinner
1979/04/04 New Pistons And Timing Advance Unit Give Better Emissions Control And Easier Starts
1979/04/04 A Reverse Connection Of Oil Filter Hoses Can Cause Bearing Failures
1979/04/04 Fabricated Air-To-Water Aftercooler Available For Dynamometer Testing Of Engines Equipped With Air-To-Air Aftercoolers
1979/04/04 Improved Fuel Priming Pumps Give Longer Service Life
1979/04/04 New Woodward Governor Control Used On Diesel Engines; Former Control Now Used On Gas Engines Only
1979/04/25 New Exhaust Valve Has Improved Three-Piece Construction
1979/04/25 Dowtherm Test Strips No Longer Available
1979/04/25 During Installation Of Crankshaft Piston Ring Seals, Put Silicone Grease In The Groove And On The Seal
1979/04/25 Stronger Output Shaft Now Used In 2N3909 Tachometer Drive Adapter
1979/05/09 New Ring Gears Used In Flywheel Assemblies
1979/05/09 Improved Gasket Now Used Between The Flywheel Housing And The Cylinder Block
1979/05/09 New " Drive 6V94 Universal Joint Is Available
1979/05/09 Part Numbers Of Bearings To Use For Service Replacement In Fuel Injection Pump Housings For Sleeve Metering Fuel Systems; Correction To Special Instruction For Installation.
1979/05/09 How To Adapt The 5P1759 Tachometer Drive Group (Dealer Tool) To D353 Engines Equipped With Electric Hour Meters When Engine RPM Must Be Checked
1979/05/09 New Oil Pump Has Improved Relief Valve For Better Pressure Control
1979/05/09 Use New Adapter To Make Tests Of 9L6884 Nozzles
1979/05/09 List Of Service Publications