Fabricated Air-To-Water Aftercooler Available For Dynamometer Testing Of Engines Equipped With Air-To-Air Aftercoolers
Usage:
A drawing for a fabricated air-to-water aftercooler, used for dynamometer testing of engines equipped with air-to-air aftercoolers, is available from your Caterpillar Dealer. The FT1438 Dynamometer Testing Aftercooler gives the same results as an air-to-air aftercooler. It can keep the temperature of the air inside the inlet manifold at a maximum of 150° F (66° C) for engines up to 1000 horsepower. The former FT1198 Aftercooler simulator, which was limited to 450 horsepower, has been canceled.
Caterpillar Information System:
1979/04/04 Improved Fuel Priming Pumps Give Longer Service Life
1979/04/04 New Woodward Governor Control Used On Diesel Engines; Former Control Now Used On Gas Engines Only
1979/04/04 List Of Service Publications
1979/04/04 Four Crankshaft Rear Seals Are Available For Use On 3304 And 3306 Engines
1979/04/04 New Oil Jet Tube In Cylinder Block Gives More Clearance For Pistons And Connecting Rods
1979/04/04 New Fabricated Tools Available For Service Work On 7211 And 7221 Marine Transmissions
1979/03/14 Replacement Bushing Available For Cast Iron Rocker Arms Only
1979/03/14 Information About The Use Of Earlier Cylinder Heads And Liners With Spacer Plate Cylinder Blocks; List Of Earlier Articles
1979/03/14 Revision To Guideline For Reusable Parts Is Available
1979/03/14 List Of Service Publications
1979/03/14 Larger Diameter Washer Is Used To Hold Air Transfer Pipe In Aftercooler Flange
1979/03/14 Maintenance Procedures For Extended FPTO Life On 3408 And 3412 Marine Engines
1979/04/04 A Reverse Connection Of Oil Filter Hoses Can Cause Bearing Failures
1979/04/04 New Pistons And Timing Advance Unit Give Better Emissions Control And Easier Starts
1979/04/25 6V112 Repair Kit Available For Parts Service Of The 8H8558 Nut Spinner
1979/04/25 Inspection Of Connecting Rods In Parts Stocks
1979/04/25 Conversion Group Available To Install Woodward Governor On Engines Equipped With Mechanical Governor
1979/04/25 Careful, Correct Installation And Maintenance Of Fuel Injection Lines Is Very Important To Prevent Possible Engine Damage, Fire And Other Problems
1979/04/25 Inspection Of Oil Pump After Long Periods Of Service Can Prevent Engine Damage
1979/04/25 How To Extend The Service Life Of 1P5550 Fuel Cam Locking Tool Assembly
1979/04/25 New Oil Cooler Bonnets Used On 3408 And 3412 Engines
1979/04/25 Inspection Of Oil Filters In Parts Stocks
1979/04/25 New Exhaust Valve Has Improved Three-Piece Construction
1979/04/25 Dowtherm Test Strips No Longer Available