6V117 And 6V2001 Bushings Used In 9S8140 Pressurizing Pump Group Are Available For Parts Service{0651}
Usage:
The 6V117 and 6V2001 Bushings are now available for parts service for use in the 9S8140 Pressurizing Pump Group. The 6V117 Bushing is used to seal the radiator filler neck and the 6V2001 Bushing is used as part of the 2P2329 Adapter (see the illustration).
6V117 and 6V2001 Bushings.
9S8140 Pressurizing Pump Group.
Caterpillar Information System:
1979/06/18 Shorter Bolt Used In BrakeSaver Manifold To Prevent Possible Contact With Bolt In Transmission{1155,1013}
1979/06/18 During Installation Of An Auxiliary Bypass Oil Filter, Be Sure Passage In Oil Cooler Fitting Is Open{1314,1378}
1979/06/18 Temperature Compensator Conversion Group Available For Fuel System To Prevent Low Power Output{1250}
1979/06/11 Test Specifications Now Available For 9N3979 And 9N2366 Pencil Type Fuel Nozzle Assemblies{0652,1254}
1979/06/11 New Specification For Installation Of Camshaft Front Bearing In Cylinder Block{1211}
1979/06/04 New Centering Rings For Oversized Main Bearings{0665,1230}
1979/06/04 Check Crankshaft Seals During Installation Of Engine Overhaul Gasket Kits; Add A Wear Sleeve When Needed{7555,7558,1161}
1979/06/04 New Caterpillar Yellow Paint{0670}
1979/06/04 New "L-Shaped" Clutch Plates Now Used{3302}
1979/05/28 Correct Locations To Connect Gauges For Checks Of Engine Oil Temperature And/Or Pressure{7455,7450,1300}
1979/05/28 New Type Products Available To Clean Cooling Systems{1350}
1979/05/28 Seat Belt Maintenance{7327}
1979/06/25 Use Of 9S3265 Retaining Compound On Schwitzer Turbocharger Compressor Wheel Retainer Nuts{1052,1053}
1979/06/25 6V183 Gasket Now Available For Parts Service To Use On 5P4150 Or 8S2242 Nozzle Tester{0651}
1979/06/25 New Water Pump Assemblies Use An Improved Seal Assembly{1361}
1979/06/25 Engine Front Support Now Machined To Prevent Possible Failure Of The Support Brackets For the Power Takeoff{1153,3055}
1979/06/25 New Air Inlet Tube Gives Enough Room To Install A "Jake Brake"{1058,1119}
1979/06/25 6V2010 Polishing Stone Available{0622}
1979/07/02 To Prevent A Possible Change In The Fuel Rack Setting, A Specific Assembly Procedure Must Be Used To Tighten The Bolt On The Governor Stop Collar{1259,1257,1250}
1979/07/02 6V109 Torque Multiplier Available For Use With Hydraulic Cylinder Repair Stand{0614}
1979/07/02 Improved Engine Design Uses Cylinder Block With Spacer Plate And New Crankshaft Thrust Plates{1000}
1979/07/02 Fuel Injection Line For Injection Test Bench Is Available From Caterpillar{0652,1250}
1979/07/09 Caution Label Added To 5P4150 Nozzle Testing Group{0651}
1979/07/09 New Valve Cover Gasket Has Better Material{1107}