1985/02/11 Caterpillar


Install Crankshaft Thrust Bearings Correctly To Avoid Damage{1202,1203}

Usage:


3400 Series Engines

It is possible to incorrectly install the 1W5252 Crankshaft Thrust Bearing during engine rebuild or when new bearings are rolled in. The thrust bearings can be installed backwards, causing possible crankshaft damage or bearing failure.

The back of each thrust bearing has "This Side Toward Block" stamped on it and a locating tab to prevent incorrect installation. However, the thrust bearings can be rolled in backwards by force. Use care to avoid this during engine overhaul.

Caterpillar Information System:

1985/02/11 New Flashlight On 6V5000 Infrared Thermometer Group{0776}
1985/02/04 New Temperature Recorders Available{0600}
1985/02/04 Over Fueling Spring No Longer Used In Governor{1264,1250}
1985/02/04 Only The External Needle Valve Can Be Adjusted On Woodward EG3PC Or EG10PC Actuators{1265,1289}
1985/02/04 Tighten Bolts To Correct Torque In 3161 Governor{1264}
1985/02/04 Wiring Harness Conduit Component Sizes{1400,1408}
1985/02/04 Correct Service Information For Air Fuel Ratio Controls Is Available In The Latest Service Manual{1278,1250}
1985/02/04 Use Care When Removing Oil Pan And 9N3167 Plate{1302}
1985/01/28 New Service Tools Available{0600}
1985/01/28 Low Oil Level In Governor Can Cause Erratic Engine RPM{1287}
1985/01/21 Exhaust Brake Performance Increased{1018}
1985/01/21 New Rear Crankshaft Seal Has Longer Service Life{1161}
1985/02/11 New Guide Assembly Used In Oil Level Gauge Group{1326,1300}
1985/02/11 Addition Of Lubricator Will Help Prevent Corrosion In Air Prelube Motors{1319}
1985/02/18 Increased Preload Used In Air Shutoff Actuators{7400,7418}
1985/02/18 New Pressure Conversion Chart Available{0600}
1985/02/18 New Transmission Control Valve And Pressure Relief Valve Are Used With High Flow Oil Pump{3313,3310}
1985/02/18 Bleed Holes On Parts Service Cylinder Heads{1100,1101}
1985/02/18 New Drive Coupler Kit Used On Altronic Magneto{1552}
1985/02/18 Low Maintenance High Output Batteries Are Now Standard Equipment{1401}
1985/03/04 Use The Correct Oil In Natural Gas Engines{1318,0374}
1985/03/04 3406B Truck Engines Have Been Improved For 1985{1000,1050,1052,1100,1200,1250}
1985/03/04 New Water Cooled Exhaust Manifold Elbows And Rear Manifold Are Used{1059}
1985/03/04 Discontinued D.C. Generators Replaced By Alternators{1404,1405}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.