Remanufactured Cylinder Head Groups{1100,1101,7554}
Usage:
3208, 3306, 3406 And 3408 Engines
An article on this same subject was published in Service Magazine, February 13, 1984. The earlier article did not have complete information. Put a mark through the earlier article and make reference to this article.
Remanufactured cylinder head groups are now available in the United States and Canada for the above engines. These remanufactured cylinder heads include all the components of a standard cylinder head group. The cylinder heads which are shown in the chart can be returned for core credit. For additional information, on these remanufactured cylinder head groups see IRM REMFGD 84-9.
Caterpillar Information System:
1984/11/19 Use Care When Installing Circuit Boards In Regulators{4467}
1984/11/05 Thread Identification Kit Available{0600,0760}
1984/11/05 Preferred Engine Timing Procedures{1250,1286,1290,1292}
1984/11/05 Remove Diode Assemblies From Shutoff Solenoids{1259}
1984/10/29 New Outer Bearing Race Used In Auxiliary Fan Drive Group{1390}
1984/10/29 New Diaphragm Used In BrakeSaver Control Valve Group{1159,1155}
1984/10/29 New Cylinder Heads, Fuel Nozzles And Fuel Nozzle Adapters Used{1101,1106}
1984/10/29 New Heat Shield For Wiring To Electrical Shutoff Group{7400,7403,7418}
1984/10/29 New Cylinder Head Gasket Helps Prevent Oil Leakage Around Gear Pocket{1101}
1984/10/29 New Oil Filter Group Can Be Used To Extend Oil Change Interval{1306,1318,1326}
1984/10/29 Foil Shield Will Help Prevent Electrical Interference In Engine Set Point Indicator{0781,0785}
1984/10/29 Cetane Injection Group Uses New Orifice, Tee and Seals{1250,1274}
1984/11/19 Additional Information For Correct Fuel Injector Timing{1290}
1984/11/19 Fuel Setting And Related Information Microfiche Corrected, Improved{0374,0375}
1984/11/19 Remanufactured Piece Parts Now Available For Turbochargers (U.S. and Canada Only){1052,1053,1056,1065,1077}
1984/11/26 Causes And Correction Of Opposite Crankshaft Rotation In Direct Injection Engines{1000}
1984/11/26 Rear Power Take-Off Clutch Can Use Nonmetallic Plates And Grease Lubrication For Main Bearings{3055,3305}
1984/11/26 Important Differences In Engine Arrangements On 3208 Engines Equipped With Turbochargers{1000}
1984/11/26 Identification Of Camshaft Groups And Valve Mechanism Groups{1210,1102}
1984/11/26 New Fuel Injector Assembly Reduces Smoke When Operating At Lower RPM And Load{1251,1250}
1984/12/10 Fill Oil Sump Before Installing Woodward Governor{1264,1288,1289}
1984/12/10 New Pressure Gauges Have Dual Scales [kPa (psi)]{0600}
1984/12/10 Lubrication Decals (Films) Are No Longer Used On Machines{7557}
1984/12/10 Starters That Remain Engaged After Engine Is Running{1453}