6V4869 Adapter And 6V6174 Plug Can Be Used To Install Camshaft Bearings{1211,0621}
Usage:
All 3400 Series Engines
The 6V4869 Adapter and 6V6174 Plug are now available for use in the installation and removal of camshaft bearings in the above engines. These two new tools are designed specifically for use on 3400 Series Engines. The new adapter and plug are used instead of the 8S8285 Collet Assembly and 8S8288 Cone, respectively. The collet assembly and cone are components of the 8S2241 Camshaft Bearing Installation And Removal Tool Group and are made to be used on bearings with smaller outside diameters. The new adapter and plug are used with the rest of the tools in the 8S2241 Group. The existing installation and removal procedures in the Service Manuals can still be used.
Caterpillar Information System:
1982/11/15 Repair Kits Available For Air Compressor{1803}
1982/11/15 Crankshaft Has Step At Front Of No. 1 Main Bearing Journal{1202}
1982/11/15 Make Change To 6V2100 Multitach And 5P9698 Calibrator{0651}
1982/11/08 High Compression Pistons Can Be Used In Engines Used At High Altitudes{1214}
1982/11/08 Mechanical Shutoff Groups Changed To Prevent Vibration Of Oil Line Tubes{7418}
1982/11/08 Do Not Center-Tap Batteries In 24-Volt System To Operate 12-Volt Accessories{1400,7300}
1982/11/08 Fabricated Adapter Will Fasten Hydraulic Cylinders To Test Stands{0626,0665,5000}
1982/11/08 6V6175 And 6V6176 Torque Adapters Make Installation Of Fuel Pump Drive Gear Easier{1206,1272,0614}
1982/11/08 New Gears Will Decrease Noise Level{3304}
1982/11/08 Use 6V6147 Polishing Wheel To Clean Piston Pins{0675,1214}
1982/11/08 New Fuel Bleed Valve Used{1262}
1982/11/08 Removal Of Hydraulic Override From Fuel Ratio Control{1278}
1982/11/22 Use the 6V6167 Contact Point to Measure Wear Steps on Piston Pins{0653}
1982/11/22 New Seal Used On Governor Control Shaft{1264,1265}
1982/11/22 Service Parts Available For The 5P4150 Nozzle Testing Group{0651,0652}
1982/11/29 Improvements Made To Fuel Ratio Control {1278}
1982/11/29 Use FT1711 Light Table For Cylinder Liner Inspection {0652,1216}
1982/11/29 Inspection Of Equipment After It Has Been In Storage {0355}
1982/11/29 Transmission Pump Failure Can Be Caused By Worn Splines Or Slot In Pump Drive {3153}
1982/11/29 Hose Presses Can Now Be Used To Service 12.7 mm (.50") JIC Couplings {0623,0624,7554}
1982/11/29 New 6V7059 Micrometer Measures Liner Top Flange And Valve Lip {0653,1216,1105}
1982/11/29 New 6V6146 Load Leveler Can Lift Larger Components {0644}
1982/11/29 Removal Of Water Pump Impeller {1361}
1982/11/29 New Flexible Coupling Group Must Be Installed Correctly {3300,3252}