Engine Front Support
Usage:
Remove & Install Engine Front Support
Start By:
a. remove vibration damper and pulley
1. Remove all bolts that hold the engine front and rear support to the base.
Typical Example
2. Fasten tool (A) to the cylinder head, as shown. Fasten a hoist to tool (A) and the lifting bracket on the other cylinder head.
3. Lift the front of the engine enough so that blocks (1) can be installed under the oil pan, as shown. The weight of the front end of the engine is approximately 1134 kg (2,500 lb).
4. Remove eight bolts from the engine front support.
5. Use two people to remove the front engine support.
6. Reverse Steps (1) thru (5) for installation.
End By:
a. install vibration damper and pulley
Caterpillar Information System:
3412C GENERATOR SET ENGINE Crankshaft Front Seal & Wear Sleeve
3412C GENERATOR SET ENGINE Vibration Damper & Pulley
3412C GENERATOR SET ENGINE Belts
3412C GENERATOR SET ENGINE Fan
3412C GENERATOR SET ENGINE Radiator
3412C GENERATOR SET ENGINE Spacer Plates
3412C GENERATOR SET ENGINE Valve Seat Inserts
3412C GENERATOR SET ENGINE Bridge Dowels
3412C GENERATOR SET ENGINE Valve Guides
3412C GENERATOR SET ENGINE Valves
3412C GENERATOR SET ENGINE Cylinder Head
3412C GENERATOR SET ENGINE Alternator
3412C GENERATOR SET ENGINE Timing Gear Cover
3412C GENERATOR SET ENGINE Camshaft
3412C GENERATOR SET ENGINE Camshaft Bearings
3412C GENERATOR SET ENGINE Timing Gears
3412C GENERATOR SET ENGINE Crankshaft Rear Seal & Wear Sleeve
3412C GENERATOR SET ENGINE Flywheel
3412C GENERATOR SET ENGINE Flywheel Housing
3412C GENERATOR SET ENGINE Pistons
3412C GENERATOR SET ENGINE Cylinder Liners
3412C GENERATOR SET ENGINE Connecting Rod Bearings
3412C GENERATOR SET ENGINE Crankshaft
3412C GENERATOR SET ENGINE Crankshaft Main Bearings