Belts
Usage:
Remove & Install Belts
Start By:
remove fan assembly
1. Loosen fan drive bolts (1). Loosen fan drive adjustment nut (2). Remove the V-belts.
NOTE: The following steps are for installation of the belts.
2. Install a matched set of V-belts.
3. Tighten the fan drive adjustment nuts (3) until the V-belts are tightened to the proper tension. See "Belt Tension Chart" in Testing and Adjusting.
4. Tighten the fan drive mounting nuts (2).
End By:
a. install fan assembly
Caterpillar Information System:
3412C GENERATOR SET ENGINE Fan
3412C GENERATOR SET ENGINE Radiator
3412C GENERATOR SET ENGINE Spacer Plates
3412C GENERATOR SET ENGINE Valve Seat Inserts
3412C GENERATOR SET ENGINE Bridge Dowels
3412C GENERATOR SET ENGINE Valve Guides
3412C GENERATOR SET ENGINE Valves
3412C GENERATOR SET ENGINE Cylinder Head
3412C GENERATOR SET ENGINE Alternator
3412C GENERATOR SET ENGINE Valve Lifters & Push Rods
3412C GENERATOR SET ENGINE Rocker Shaft Assembly
3412C GENERATOR SET ENGINE Valve Covers
3412C GENERATOR SET ENGINE Vibration Damper & Pulley
3412C GENERATOR SET ENGINE Crankshaft Front Seal & Wear Sleeve
3412C GENERATOR SET ENGINE Engine Front Support
3412C GENERATOR SET ENGINE Timing Gear Cover
3412C GENERATOR SET ENGINE Camshaft
3412C GENERATOR SET ENGINE Camshaft Bearings
3412C GENERATOR SET ENGINE Timing Gears
3412C GENERATOR SET ENGINE Crankshaft Rear Seal & Wear Sleeve
3412C GENERATOR SET ENGINE Flywheel
3412C GENERATOR SET ENGINE Flywheel Housing
3412C GENERATOR SET ENGINE Pistons
3412C GENERATOR SET ENGINE Cylinder Liners