Valve Covers
Usage:
Remove & Install Valve Covers
1. Remove seven bolts (1).
2. Remove valve cover (2).
NOTE: The following steps are for the installation of the valve covers.
3. Make sure the seal is in position on the valve cover. Install valve cover (2).
4. Install seven bolts (1).
5. Use the tightening sequence above to tighten the bolts to a torque of 14 ± 4 N·m (10 ± 3 lb ft).
Caterpillar Information System:
3412C GENERATOR SET ENGINE Exhaust Manifold
3412C GENERATOR SET ENGINE Turbocharger (Engines With One Turbocharger)
3412C GENERATOR SET ENGINE Turbocharger (Engines With Two Turbochargers)
3412C GENERATOR SET ENGINE Turbocharger (Left Side & Rear) STA
3412C GENERATOR SET ENGINE Aftercooler Core
3412C GENERATOR SET ENGINE Air Cleaner
3126B and 3126E On-highway Engines Electrical System 3126B and 3126E On-highway Engines Electrical System
FLO-TECH SPEED CONTROL ELECTRONIC SPEED CON Chapter 6 Repair and Replacement
FLO-TECH SPEED CONTROL ELECTRONIC SPEED CON Chapter 5 Troubleshooting
FLO-TECH SPEED CONTROL ELECTRONIC SPEED CON Chapter 4 Description of Operation
FLO-TECH SPEED CONTROL ELECTRONIC SPEED CON Chapter 3 Calibration and Operation
FLO-TECH SPEED CONTROL ELECTRONIC SPEED CON Chapter 2 Installation
3412C GENERATOR SET ENGINE Rocker Shaft Assembly
3412C GENERATOR SET ENGINE Valve Lifters & Push Rods
3412C GENERATOR SET ENGINE Alternator
3412C GENERATOR SET ENGINE Cylinder Head
3412C GENERATOR SET ENGINE Valves
3412C GENERATOR SET ENGINE Valve Guides
3412C GENERATOR SET ENGINE Bridge Dowels
3412C GENERATOR SET ENGINE Valve Seat Inserts
3412C GENERATOR SET ENGINE Spacer Plates
3412C GENERATOR SET ENGINE Radiator
3412C GENERATOR SET ENGINE Fan
3412C GENERATOR SET ENGINE Belts