3412C GENERATOR SET ENGINE Caterpillar


Exhaust Manifold

Usage:

Remove Exhaust Manifold (STA) & (TTA)

Start By:

a. remove side turbocharger

b. remove turbocharger assembly


STA

1. Remove shield (1) from exhaust manifold (2).


STA

2. Remove twelve nuts (3). Remove exhaust manifold (2) and gaskets.


TTA

3. Remove clamp (8).

4. Remove twelve nuts (4). Remove exhaust manifold (2) and gaskets.

5. Make a separation of section (7), four sections (6), and section (5).

Install Exhaust Manifold


NOTICE

Make sure the 2P2333 Manifold Sealer does not get on the inside of each manifold. Damage to the turbocharger could be the result if the manifold sealer gets on the impeller on the turbocharger.


1. Put 2P2333 Manifold Sealer on the male portion of the connecting surfaces of four sections (7) and one section (8).

2. Make a connection of sections (6), four sections (7), and section (8).

3. Install 5P3931 Anti-Seize Compound on the threads of studs.

4. Install the gaskets on the studs.

5. Install exhaust manifold (3).

6. Install nuts, spacers and brackets (5). Tighten the nuts to a torque of 52 ± 7 N·m (38 ± 5 lb ft).

7. Install clamp (9).

8. Install shield (2) to exhaust manifold (3).

9. Using a new O-ring seal at the bottom and a new gasket at the top, install turbocharger return oil line.

End By:

install side turbocharger

Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.