Fuel Transfer Pump
Usage:
Remove and Install Fuel Transfer Pump
1. Disconnect fuel lines (1) and (2). Plug and cap all openings to prevent debris and contamination from entering the system.
2. Remove bolts (3) and fuel transfer pump (4).
3. Check the condition of the O-ring seal (5) on the fuel transfer pump. If the part is worn or damaged, replace the part.
NOTE: The following steps are for installation of the fuel transfer pump.
4. Be sure the O-ring seal is in position on the fuel transfer pump. Put clean engine oil on the O-ring seal.
5. Put fuel transfer pump (4) in position, and install bolts (3) that hold it in place.
6. Remove the caps from the fuel line openings. Install fuel lines (1) and (2).
Caterpillar Information System:
3406E TRUCK ENGINE Fuel Filter and Base
3406E TRUCK ENGINE Fuel Priming Pump
3406E TRUCK ENGINE Air Compressor - Remove and Install
ELECTRONIC MODULAR CONTROL PANEL II+ (EMCP II+) FOR PEEC ENG Testing And Adjusting
ELECTRONIC MODULAR CONTROL PANEL II+ (EMCP II+) FOR PEEC ENG Systems Operation
GENERATOR SET CONTROL PANEL WITH AUTO START/STOP Testing And Adjusting
GENERATOR SET CONTROL PANEL WITH AUTO START/STOP Systems Operation
GENERATOR SET CONTROL PANEL FOR SWITCHGEAR CONVERSION Testing And Adjusting
GENERATOR SET CONTROL PANEL FOR SWITCHGEAR CONVERSION Systems Operation
KCR-760 VOLTAGE REGULATOR FOR SR4 HV Testing And Adjusting
KCR-760 VOLTAGE REGULATOR FOR SR4 HV Systems Operation
KCR-760 VOLTAGE REGULATOR FOR SR4 HV Application
3406E TRUCK ENGINE Electronic Control Module
3406E TRUCK ENGINE Electronic Unit Injectors
3406E TRUCK ENGINE Injector Sleeves
3406E TRUCK ENGINE Electric Starting Motor
3406E TRUCK ENGINE Turbocharger
3406E TRUCK ENGINE Water Temperature Regulators
3406E TRUCK ENGINE Engine Oil Cooler
3406E TRUCK ENGINE Oil Filter and Base
3406E TRUCK ENGINE Exhaust Manifold
3406E TRUCK ENGINE Water Pump
3406E TRUCK ENGINE Fan Drive
3406E TRUCK ENGINE Engine Front Support