WOODWARD REPAIR MANUAL FOR DIASSEMBLY AND REASSEMBLY PROCEDU Caterpillar


Chapter 1. 120 mm Throttle Valve with Actuator Parts

Usage:

NOTE: Disassembling the throttle will void the warranty.

Parts Description

1. Throttle Housing
2. Shaft/Housing Needle Bearing (6V-2830)
3. End Cap O-Ring (5P-5599)
4. End Cap
5. End Cap Screws (2)
6. Butterfly Plate Screws (3) (331-1698)
7. Butterfly Plate (331-2910)
8. Plug
9. Shaft (331-2905)
10. Flat Washers (4)
11. Nylok Nuts (4)
12. Screws (4)
13. Actuator
14. Shaft Coupler
15. Carrier Assembly (331-2904)
16. Carrier Screws (2)
17. O-Ring (144-7338)
18. Washer (4)
19. O-Ring (033-6042)
20. Drive Screw (2) N/S
21. Nameplate (N/S)


Figure 1-1. Parts Description

Caterpillar Information System:

Improved Straight-Faced Wiper Seals{7555, 7562} Improved Straight-Faced Wiper Seals{7555, 7562}
Installation Procedure For The 136-4304 Wiring Harness Assembly{1090} Installation Procedure For The 136-4304 Wiring Harness Assembly{1090}
Conversion Of Generators From Self-Excited To Permanent Magnet{4450} Conversion Of Generators From Self-Excited To Permanent Magnet{4450}
PTO Installation And Applications Instruction{1165} PTO Installation And Applications Instruction{1165}
Repair Procedure: 3600 Series Cylinder Heads - Blended Fuel{1100} Repair Procedure: 3600 Series Cylinder Heads - Blended Fuel{1100}
Instructions For EMCP II+ Field Retrofit Onto EMCP II Equipped Generator Sets{7490, 7451} Instructions For EMCP II+ Field Retrofit Onto EMCP II Equipped Generator Sets{7490, 7451}
Installing the Air Inlet Heater System{1090} Installing the Air Inlet Heater System{1090}
Generator Set Start-up Checklist{1021, 1404, 7002} Generator Set Start-up Checklist{1021, 1404, 7002}
Calibrating The 133-8985 Governor And Fuel Injection Pump Group Heavy Sleeve Metering Fuel System (HSMFS){650, 1250} Calibrating The 133-8985 Governor And Fuel Injection Pump Group Heavy Sleeve Metering Fuel System (HSMFS){650, 1250}
Installation Procedure For The 138-7020 Harness Assembly{1408} Installation Procedure For The 138-7020 Harness Assembly{1408}
5.4" BORE, 60 V12 VEHICULAR ENGINE V-Belt Tension Chart
5.4" BORE, 60 V12 VEHICULAR ENGINE Voltmeter
WOODWARD REPAIR MANUAL FOR DIASSEMBLY AND REASSEMBLY PROCEDU Chapter 2. 120 mm Throttle Valve with Actuator Disassembly
WOODWARD REPAIR MANUAL FOR DIASSEMBLY AND REASSEMBLY PROCEDU Chapter 3. 120 mm Throttle Valve with Actuator Reassembly
Caterpillar Post Installation Compatibility Assessment for Stationary Engines Caterpillar Post Installation Compatibility Assessment for Stationary Engines
Caterpillar Post Installation Compatibility Assessment for *NEW* Stationary Engines Caterpillar Post Installation Compatibility Assessment for *NEW* Stationary Engines
Cat� Retrofit Selective Catalyst Reduction System Commissioning Report Cat� Retrofit Selective Catalyst Reduction System Commissioning Report
Compressed Air Packaged System Compressed Air Packaged System
High Pressure Fuel Pump Return Form High Pressure Fuel Pump Return Form
3176C & 3196 MARINE ENGINES Systems Operation
3176C & 3196 MARINE ENGINES Testing & Adjusting
BENDIX AIR COMPRESSOR 1W150R AIR COMPRESSO Introduction
BENDIX AIR COMPRESSOR 1W150R AIR COMPRESSO Description
BENDIX AIR COMPRESSOR 1W150R AIR COMPRESSO Air Compressor Components
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.