3204 VEHICULAR ENGINE FOR D3 TRACTOR, 931 TRACK-TYPE LOADER Caterpillar


Crankshaft Rear Seal And Wear Sleeve

Usage:

Remove Crankshaft Rear Seal And Wear Sleeve

start by:

a) remove flywheel

NOTE: When a replacement of the rear seal is made, a replacement of the wear sleeve is to be made also.

1. Remove the crankshaft rear seal with tool (A).


TYPICAL EXAMPLE

2. Install tool (C) in the rear seal bore.

3. Install tool (B) between tool (C) and wear sleeve. Turn tool (B) until the edge of the tool makes a flat place (crease) in the wear sleeve. Do this in two or more places until the wear sleeve is loose.

4. Remove tool (C) and the wear sleeve by hand.

Install Crankshaft Rear Seal And Wear Sleeve

1. Install the crankshaft rear seal and wear sleeve with tooling (A) as follows:

a) Clean and make a preparation of the wear sleeve inside diameter and crankshaft outside diameter with 8M8060 Quick Cure Primer. Make an application of 9S3265 Retaining Compound to crankshaft outside diameter and wear sleeve inside diameter before the wear sleeve is installed on the crankshaft.

b) Install locator (3) and the bolts on the rear of the crankshaft.

c) Put clean engine oil on the lip of seal (1) and install the seal on wear sleeve (2).

d) Put 7F2770 Cement on the outer metal surface of the seal.

e) Put the wear sleeve (2) and seal (1) in position on locator (3) with the outside diameter bevel of the wear sleeve toward the outside.

NOTE: Make sure the lip of the seal is toward the front of the engine before the seal is pushed in position as shown.

f) Put installer (5) in position on the locator.

g) Put clean engine oil on the face of nut (4) and install it on the locator. Tighten the nut until installer (5) is at bottom.

h) Remove tooling (A) and check the wear sleeve and seal for the correct position after installation. The wear sleeve must be even with the flywheel mounting flange.

end by:

a) install flywheel

Caterpillar Information System:

3204 VEHICULAR ENGINE FOR D3 TRACTOR, 931 TRACK-TYPE LOADER Flywheel Housing
3204 VEHICULAR ENGINE FOR D3 TRACTOR, 931 TRACK-TYPE LOADER Flywheel Ring Gear
3204 VEHICULAR ENGINE FOR D3 TRACTOR, 931 TRACK-TYPE LOADER Flywheel
3204 VEHICULAR ENGINE FOR D3 TRACTOR, 931 TRACK-TYPE LOADER Timing Gears And Plate
3204 VEHICULAR ENGINE FOR D3 TRACTOR, 931 TRACK-TYPE LOADER Camshaft Bearings
3204 VEHICULAR ENGINE FOR D3 TRACTOR, 931 TRACK-TYPE LOADER Camshaft
3204 VEHICULAR ENGINE FOR D3 TRACTOR, 931 TRACK-TYPE LOADER Oil Pump And Relief Valve
3204 VEHICULAR ENGINE FOR D3 TRACTOR, 931 TRACK-TYPE LOADER Timing Gear Cover
3204 VEHICULAR ENGINE FOR D3 TRACTOR, 931 TRACK-TYPE LOADER Crankshaft Front Seal
3204 VEHICULAR ENGINE FOR D3 TRACTOR, 931 TRACK-TYPE LOADER Crankshaft Front Pulley
3204 VEHICULAR ENGINE FOR D3 TRACTOR, 931 TRACK-TYPE LOADER Exhaust Manifold
3204 VEHICULAR ENGINE FOR D3 TRACTOR, 931 TRACK-TYPE LOADER Accessory Drive Housing
3204 VEHICULAR ENGINE FOR D3 TRACTOR, 931 TRACK-TYPE LOADER Crankshaft And Gear
3204 VEHICULAR ENGINE FOR D3 TRACTOR, 931 TRACK-TYPE LOADER Hood
3204 VEHICULAR ENGINE FOR D3 TRACTOR, 931 TRACK-TYPE LOADER Air Cleaner Housing
3204 VEHICULAR ENGINE FOR D3 TRACTOR, 931 TRACK-TYPE LOADER Muffler
3204 VEHICULAR ENGINE FOR D3 TRACTOR, 931 TRACK-TYPE LOADER Radiator And Guard Assembly
3204 VEHICULAR ENGINE FOR D3 TRACTOR, 931 TRACK-TYPE LOADER Engine
3204 VEHICULAR ENGINE Systems Operation
3204 VEHICULAR ENGINE Testing And Adjusting
910 WHEEL LOADER POWER TRAIN Systems Operation
910 WHEEL LOADER POWER TRAIN Testing And Adjusting
910 WHEEL LOADER STEERING AND BRAKE SYSTEMS Systems Operation
910 WHEEL LOADER STEERING AND BRAKE SYSTEMS Testing And Adjusting
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.