PRODUCT SUPPORT PROGRAM FOR REPLACING CYLINDER LINERS ON CERTAIN G3516E, AND G3520E GENERATOR SETS Caterpillar


PRODUCT SUPPORT PROGRAM FOR REPLACING CYLINDER LINERS ON CERTAIN G3516E, AND G3520E GENERATOR SETS

Usage:

REBE8688-01

27Aug2012
(Revised 08Jan2013)


U-450
D-386
O-415

 

After Failure Only

  
  

PRODUCT SUPPORT PROGRAM FOR REPLACING CYLINDER LINERS ON CERTAIN G3516E, AND G3520E GENERATOR SETS

1216 1239 1225
PS52278
NOTE:

This Program can only be administered after a failure occurs. The decision whether to apply the Program is made by the dealer. When reporting the repair, use "PS52278" as the Part Number and "7755" as the Group Number. Use "96" as the Warranty Claim Description Code and use "Z" as the SIMS Description Code.

NOTE:

The information supplied in this service letter may not be valid after the termination date of this program. Do not perform the work outlined in this Service Letter after the termination date without first contacting your Caterpillar product analyst.

 
NOTE:

This Revised Service Letter replaces the 27Aug2012 Service Letter. Changes have been made to the Parts Needed.


TERMINATION DATE

31Aug2014

PROBLEM

Oil consumption on the existing power packs can be elevated to the point of detonation on certain G3516E, and G3520E Generator Sets. If the existing engine is experiencing single cylinder detonation and all the troubleshooting guide steps have been completed, changing the cylinder pack may be required to resolve the issue.

AFFECTED PRODUCT

Model Identification Number
G3516E GAS00111-00280

SLY00106-00109
G3520E GZH00111-00167

HAL00100-00102

PARTS NEEDED

Qty

Part Number Description
3 7N2046 SEAL-O-RING
1 8N4707 BAND-FILLER
1 1077330 BEARING-CONN ROD
1 2236361 RING-PISTON
1 3471085 RING-PISTON
1 3481708 SLEEVE
1 3488779 RING-PISTON
1 3500074 LINER-CYLINDER
1 3550765 KIT-GASKET(SCH)
1 3764141 BODY AS -PISTON
In order to allow equitable parts availability to all participating dealers, please limit your initial parts order to not exceed 12% of dealership population. This is an initial order recommendation only, and the ultimate responsibility for ordering the total number of parts needed to satisfy the program lies with the dealer.

ACTION REQUIRED

If the engine has experienced more than four detonation shutdowns in 250 hours or less on a single cylinder, that single cylinder is subject for replacement under this Service Letter. A Product Status Report (PSR) must be generated from Cat ET showing the four shutdowns on a single cylinder within a 250 hour time frame. This PSR must be attached to the SIMSi ticket or the claim will be rejected. If there has been a pervious repair according to this Service Letter please reference the claim numbers when submitting a new claim. When the third cylinder meets the before mentioned failure criteria the remaining cylinders may be proactively replaced at that time. Refer to the Disassembly and Assembly manual for removal and installation of the cylinder pack.

SERVICE CLAIM ALLOWANCES

Product smu/age whichever comes first
Caterpillar
Dealer Suggested
Customer Suggested
Parts %
Labor Hrs%
Parts %
Labor Hrs%
Parts %
Labor Hrs%
0-8000 hrs,
0-12 mo 
100.0%
100.0%
0.0%
0.0%
0.0%
0.0%
8001-8001 hrs,
13-30 mo 
75.0%
75.0%
0.0%
0.0%
25.0%
25.0%
8002-12000 hrs,
31-50 mo 
55.0%
55.0%
0.0%
0.0%
45.0%
45.0%
12001-15000 hrs,
51-70 mo 
35.0%
35.0%
0.0%
0.0%
65.0%
65.0%
15001-20000 hrs,
71-90 mo 
20.0%
20.0%
0.0%
0.0%
80.0%
80.0%
 NOTE: This is a 9.0-hour job

If there has been a previous repair, part age/hours will apply. Retain a copy of the previous repair invoice in the dealer's records for audit purposes, and specify repair date and machine hours in the "Additional Comments" section of the warranty claim.

If only one cylinder pack is replaced up to 9 hours is allowed. An additional 7.5 hours is allowed for each additional cylinder pack that is replaced during the same service.



PARTS DISPOSITION

Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
 
 
 

Caterpillar Information System:

PRODUCT SUPPORT PROGRAM FOR REPLACING THE OIL COOLER CORE ON CERTAIN 3516C MARINE ENGINES PRODUCT SUPPORT PROGRAM FOR REPLACING THE OIL COOLER CORE ON CERTAIN 3516C MARINE ENGINES
PRODUCT SUPPORT PROGRAM FOR REPLACING THE HEUI PUMP ON CERTAIN C9 INDUSTRIAL ENGINES PRODUCT SUPPORT PROGRAM FOR REPLACING THE HEUI PUMP ON CERTAIN C9 INDUSTRIAL ENGINES
PRODUCT IMPROVEMENT PROGRAM FOR INSTALLING AIR SHUTOFF PROXIMITY SENSORS ON CERTAIN 3512C OIL WELL SERVICE ENGINES PRODUCT IMPROVEMENT PROGRAM FOR INSTALLING AIR SHUTOFF PROXIMITY SENSORS ON CERTAIN 3512C OIL WELL SERVICE ENGINES
PRODUCT SUPPORT PROGRAM FOR INSPECTING AND TIGHTENING THE RETAINER NUT ON 185-2831 FUEL INJECTION LINES ON CERTAIN 3406C GENERATOR SETS PRODUCT SUPPORT PROGRAM FOR INSPECTING AND TIGHTENING THE RETAINER NUT ON 185-2831 FUEL INJECTION LINES ON CERTAIN 3406C GENERATOR SETS
PRODUCT SUPPORT PROGRAM FOR REPLACING THE AFTERCOOLER ON CERTAIN C18 MARINE ENGINES PRODUCT SUPPORT PROGRAM FOR REPLACING THE AFTERCOOLER ON CERTAIN C18 MARINE ENGINES
PRODUCT SUPPORT PROGRAM FOR INSTALLING A REPLACEMENT ENGINE EMISSIONS LABEL ON CERTAIN 3606, 3608, 3612, 3616, 3618, C280-6, C280-8, C280-12, AND C280-16 MARINE ENGINES PRODUCT SUPPORT PROGRAM FOR INSTALLING A REPLACEMENT ENGINE EMISSIONS LABEL ON CERTAIN 3606, 3608, 3612, 3616, 3618, C280-6, C280-8, C280-12, AND C280-16 MARINE ENGINES
PRODUCT IMPROVEMENT PROGRAM FOR REWORKING THE GENERATOR BEARING AND SLEEVE ASSEMBLY ON CERTAIN 3512B GENERATOR SETS PRODUCT IMPROVEMENT PROGRAM FOR REWORKING THE GENERATOR BEARING AND SLEEVE ASSEMBLY ON CERTAIN 3512B GENERATOR SETS
PRODUCT IMPROVEMENT PROGRAM FOR REMOVING 346-3311 FUEL FILTER ELEMENTS AND 351-8680 FUEL FILTER HOUSING ASSEMBLIES FROM DEALER PARTS STOCK PRODUCT IMPROVEMENT PROGRAM FOR REMOVING 346-3311 FUEL FILTER ELEMENTS AND 351-8680 FUEL FILTER HOUSING ASSEMBLIES FROM DEALER PARTS STOCK
PRODUCT SUPPORT PROGRAM FOR UPDATING THE SOFTWARE ON CERTAIN C175-16 GENERATOR SETS PRODUCT SUPPORT PROGRAM FOR UPDATING THE SOFTWARE ON CERTAIN C175-16 GENERATOR SETS
PRODUCT SUPPORT PROGRAM FOR INSTALLING A NEW PRODUCT IDENTIFICATION NUMBER (PIN) PLATE AND A NEW ENGINE SERIAL NUMBER PLATE ON CERTAIN 3516B, AND 3516C GENERATOR SETS PRODUCT SUPPORT PROGRAM FOR INSTALLING A NEW PRODUCT IDENTIFICATION NUMBER (PIN) PLATE AND A NEW ENGINE SERIAL NUMBER PLATE ON CERTAIN 3516B, AND 3516C GENERATOR SETS
PRODUCT SUPPORT PROGRAM FOR REPAIRING A VALVE FAILURE ON CERTAIN G3508B, G3512B, G3516, AND G3516B GAS ENGINES PRODUCT SUPPORT PROGRAM FOR REPAIRING A VALVE FAILURE ON CERTAIN G3508B, G3512B, G3516, AND G3516B GAS ENGINES
PRODUCT SUPPORT PROGRAM FOR REPLACING THE ENGINE SOFTWARE ON CERTAIN C13 AND C15 ON-HIGHWAY ENGINES PRODUCT SUPPORT PROGRAM FOR REPLACING THE ENGINE SOFTWARE ON CERTAIN C13 AND C15 ON-HIGHWAY ENGINES
PRODUCT IMPROVEMENT PROGRAM FOR INSPECTING AND POSSIBLY REMOVING 10R-9602 REMAN FUEL PUMPS FROM DEALER PARTS STOCK PRODUCT IMPROVEMENT PROGRAM FOR INSPECTING AND POSSIBLY REMOVING 10R-9602 REMAN FUEL PUMPS FROM DEALER PARTS STOCK
PRODUCT IMPROVEMENT PROGRAM FOR INSPECTING WINDING LEADS ON CERTAIN C32 GENERATOR SETS PRODUCT IMPROVEMENT PROGRAM FOR INSPECTING WINDING LEADS ON CERTAIN C32 GENERATOR SETS
PRODUCT IMPROVEMENT PROGRAM FOR INSPECTING AND POSSIBLY REMOVING CERTAIN 3T-0203, 7G-8237, 8N-1525, 8N-1527, 8N-1529, 8N-1531, AND 8N-1533 ELECTRICAL CONNECTORS FROM DEALER PARTS STOCK PRODUCT IMPROVEMENT PROGRAM FOR INSPECTING AND POSSIBLY REMOVING CERTAIN 3T-0203, 7G-8237, 8N-1525, 8N-1527, 8N-1529, 8N-1531, AND 8N-1533 ELECTRICAL CONNECTORS FROM DEALER PARTS STOCK
PRODUCT SUPPORT PROGRAM FOR REPLACING THE AC SENSING HARNESS ON CERTAIN C15 AND C18 GENERATOR SETS PRODUCT SUPPORT PROGRAM FOR REPLACING THE AC SENSING HARNESS ON CERTAIN C15 AND C18 GENERATOR SETS
PRODUCT SUPPORT PROGRAM FOR REWORKING THE CRANKSHAFT TIMING WHEEL BOLTS ON CERTAIN C4.4 INDUSTRIAL ENGINES PRODUCT SUPPORT PROGRAM FOR REWORKING THE CRANKSHAFT TIMING WHEEL BOLTS ON CERTAIN C4.4 INDUSTRIAL ENGINES
PRODUCT IMPROVEMENT PROGRAM FOR INSPECTING FOR THE 393-6379 INSULATED BARRIER, AND FOR 423-1935, AND 423-1936 WARNING LABELS ON CERTAIN UPSB125 AND UPSB130 UNINTERRUPTIBLE POWER SUPPLIES WITH DOUBLE CONVERSION PRODUCT IMPROVEMENT PROGRAM FOR INSPECTING FOR THE 393-6379 INSULATED BARRIER, AND FOR 423-1935, AND 423-1936 WARNING LABELS ON CERTAIN UPSB125 AND UPSB130 UNINTERRUPTIBLE POWER SUPPLIES WITH DOUBLE CONVERSION
PRODUCT SUPPORT PROGRAM FOR REPLACING THE RATING LABEL ON CERTAIN C1.5 AND C2.2 GENERATOR SETS PRODUCT SUPPORT PROGRAM FOR REPLACING THE RATING LABEL ON CERTAIN C1.5 AND C2.2 GENERATOR SETS
PRODUCT SUPPORT PROGRAM FOR REWORKING THE EXCITER ROTOR ON CERTAIN 3512, AND 3512B GENERATOR SETS PRODUCT SUPPORT PROGRAM FOR REWORKING THE EXCITER ROTOR ON CERTAIN 3512, AND 3512B GENERATOR SETS
PRODUCT IMPROVEMENT PROGRAM FOR INSPECTING THE WINDING LEADS ON CERTAIN C32 GENERATOR SETS PRODUCT IMPROVEMENT PROGRAM FOR INSPECTING THE WINDING LEADS ON CERTAIN C32 GENERATOR SETS
PRODUCT SUPPORT PROGRAM FOR REPLACING THE 365-9786 EXPUT BOARD ASSEMBLY, 365-9798 DIGIT BOARD ASSEMBLY, AND 365-9803 EXTT BOARD ASSEMBLY ON CERTAIN UPSB505 UNINTERRUPTIBLE POWER SUPPLIES PRODUCT SUPPORT PROGRAM FOR REPLACING THE 365-9786 EXPUT BOARD ASSEMBLY, 365-9798 DIGIT BOARD ASSEMBLY, AND 365-9803 EXTT BOARD ASSEMBLY ON CERTAIN UPSB505 UNINTERRUPTIBLE POWER SUPPLIES
PRODUCT IMPROVEMENT PROGRAM FOR INSTALLING NEW SOFTWARE ON CERTAIN 3512C PETROLEUM ENGINES AND SPF343 TRAILER MOUNTED PUMPERS PRODUCT IMPROVEMENT PROGRAM FOR INSTALLING NEW SOFTWARE ON CERTAIN 3512C PETROLEUM ENGINES AND SPF343 TRAILER MOUNTED PUMPERS
PRODUCT IMPROVEMENT PROGRAM FOR INSPECTING AND POSSIBLY REMOVING CERTAIN CIRCUIT BREAKERS FROM DEALER PARTS STOCK PRODUCT IMPROVEMENT PROGRAM FOR INSPECTING AND POSSIBLY REMOVING CERTAIN CIRCUIT BREAKERS FROM DEALER PARTS STOCK
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.